Jim Misencik

Пікірлер

@nathanharris7 12 күн бұрын

great job! just what i was looking for!

@MikeBesantan Ай бұрын

Thanks for the great review! I recently purchased the OpenRun Pro 2 Mini and I really like it. My head size is 21.5 cm, as per the suggested measurement. Wearing a helmet and sunglasses is no issue at all, still plenty room!

@justin10054 Ай бұрын

I think a lot of the aurora photos are long exposures.

@alexanderikaika5125 Ай бұрын

I got a large dome… the mini fits way better for me, and for some reasons sounds much better…(at least at the best buy display)

@albictm Ай бұрын

Hey there! I have an OpenRun Pro but I don't know if it is a standard or mini (got it used). Can't find the dimensions anywhere, would you (or anyone else) be able to comment with the band measurements of either one so that I can figure out which one I have? Thank you!

@brainlam9238 Ай бұрын

mini is the way to go why would you want the excess band dangling behind you

@AshfaqDogar-y3c Ай бұрын

How valve clearance? Plz

@JD_Mortal 2 ай бұрын

Get larger, lighter aluminum rims and thinner tires. Lower volume translates to lower weight. You can get solid hubcaps, as the breaks need little cooling. Get aluminum sheet metal and try to reduce underbody voids and plug holes that don't need air flow. You can gap your front cover plate, over the grill, at the top, to gain cooling and not disrupt the aerodynamic gains much. The back spoiler is actually making drag. It creates a negative void, pulling the car backwards, while it's trying to move forward. It actually lifts the car at high speeds, as opposed to holding it down. It's a totally cosmetic add-on. Add a transmission cooler to your transmission and one to the gas line, after the pump and before the injectors. Make sure the cooling lines are insulated, so it doesn't pick up engine compartment heat. Both radiators set in front of AC radiator or at each of the two lower intakes, below the bumper. No fan needed, unless you want idle cooling too. (That would be better) The CVT cooler is barely adequate. It loves being cooler. Gas also loves being cooler. It gets hot from all the engine heat and road heat, heating the non insulated lines. Up to 135F! If you are real desperate... Run a 2" flex tube from your cabin to the air intake box. Have a 12v fan blowing cooler cabin air into the intake. As opposed to the intake sucking in too hot or too cold outside air only. (Add a flap trap to stop outside air from coming in, at high speeds. It's more for idle air balance. Not intended to be a ram-jet.) Besides removing the back seats and spare tire... Get lightweight racing seats and seat rails. Maybe replace the battery with a supercap starter and a smaller, lighter lithium battery.

@cecilezimmer8773 2 ай бұрын

Thanks, very useful! I’ve had the Aeropex version for about 4 years and really like them but they are kind of annoying when wearing anything with a hood (hoodie, rain jacket...) since the back part sticks out too much and interferes with the hood. I will try a mini version and hope that solves the issue.

@JD_Mortal 2 ай бұрын

I will argue about "driving the speed limit", as being a gas saver. I get the same 45-55 mpg going 35, 45, 55, 65 and 75 mph. It is all about going past your speed, followed by easing down into your final speed. If you just ride UP to the speed, you will likely be at the upper end of a gear. That has about 25 mpg, vs the lower end, which is close to 45-55 mpg. The biggest gas saver, besides accelerating at ideal speeds (not slow, but not fast), has been at long lights and approaching stopped traffic. My foot is off the gas and I tap the break, just enough to pull the computer out of "sustain" mode. It goes into deceleration mode, but I coast up to stopped traffic, from a great distance. (Many times never actually stopping by the time I arrive, the light has changed.) At known "long lights", I just turn off the car and wait for the light to change. (I can tell before it changes and get the car running before it actually changes.) My tires stay at 40psi, for the extra coasting speed. At 35psi, the car tends to stop faster. At 42psi, the car costs forever but it means the tires will wear more, when breaking too. 38-40psi is a nice balance. (38 when low) If you don't need the back seats and have AAA roadside assistance... Remove the back seats, spare tire and jack. Bonus for removing the passenger seat and airbag. Bigger bonus for aluminum rims and using only nitrogen for tire air. P.S. You can make a cover that allows air to flow at low speeds, for the radiator. It's called a screen. At high speeds the air creates a restriction, stopping air from entering, but not completely. At low speeds, when aerodynamics matter the least, air can flow through faster.

@daniwamoto5133 2 ай бұрын

I appreciate the length of the video, no 🐂 💩

@GuillaumeST-Jean 2 ай бұрын

What is your measurement behind you ears ? Mine is 8 1/4 inch and according to Shokz, I would need the Mini and not the Regular. What do you think?

@nayakiabates8814 3 ай бұрын

Thank you, I’m getting the mini

@sketchitoutstudios 4 ай бұрын

This helped thanks! I was trying to figure out if mini meant like kid sized but it just means a smaller gap for the loop.

@ryanstratton5895 5 ай бұрын

Now this is a proper review. 0 fluff just the facts and perfect video

@preunit13 5 ай бұрын

How much lift did you add with the ome lift kit?

@UARELOVE1010 5 ай бұрын

Do you feel that the mini is hugging your head too much than the regular?

@hanselcedillos1047 5 ай бұрын

I was unable to "loosen the clamp holding the airbox onto the throttle body." I believe it's part 90005-RGA-000, which is a 4 mm hex and a phillips or JIS head as well. I stripped both of those methods of loosening through various idiotic methods (I did not have the correct tool for the job, a 4 mm deep socket probably would have saved me a headache). However, I was able to just manhandle the airbox off. I'll have to drill out and replace the poor destroyed bolt eventually. Also it was not in the same spot as in the video. The clamp had rotated so it was in a difficult location to access. It's funny how a 5 second clip in a video can turn into an hour of sweating lol!

@gabrielperez2528 5 ай бұрын

How can I contact you for better info

@pascalh.387 5 ай бұрын

How many kilometres does the engine have?

@K03sport 7 ай бұрын

what a pain every 30k miles. I thought changing my trans and rear diff fluid every 30k on my wrx was a pain (and it was), but this somehow seems more painful. I'm all for doing simple, minor service yourself. of course I skipped my 30k mi fluid change and did it at 60k (oops). Thanks for the video. 🏁

@Jarellx2_Adventures 7 ай бұрын

Very helpful! Just the video I was searching for. Thanks

@RioHusnadyHidayat 7 ай бұрын

quick and very informative

@chrissaunders9166 7 ай бұрын

last time I tried to get Patagonia to honor their lifetime warranty, I sent in a favorite 7 yr old pair of Baggies ( in a color no longer available) and got a really disturbing letter back along with a coupon for $15 store credit. ONLY problem with the Baggies was the elastic waistband. Never again. I think LL Bean is the only company still honoring their "lifetime" warranty

@MitchellFillyaw 7 ай бұрын

Make sure you trim your bump stops

@nicholasquinn4779 7 ай бұрын

Very helpful thank you

@keefeere 8 ай бұрын

why helmet straps OVER headphones?

@tbaietto 6 ай бұрын

I thought the same thing. Also when my wife tried my non-minis on to check fit before she orders the mini - she put her long hair over the unit, not under it. Maybe it's preference.

@keefeere 6 ай бұрын

I just bought it, month ago, and do the same way😂

@TodayInTheShop 6 ай бұрын

Because otherwise you would have to thread them through the straps. Also, when you remove the helmet, you would have to remove them first, or the helmet would pull them off your head.

@meh6513 4 ай бұрын

Well the bone conduction means skin to skin contact...the strap under the headphones means the part that is supposed to press on your bone might be lifted off your skin surface ruining the sound and I think it's easier to lose them while riding since it's sticking out

@Exnihilate 9 ай бұрын

Thank you. This was the fix that worked for me. 2010 Honda fit sport

@honcoolst.2914 9 ай бұрын

The mini one fit me so much better

@mg8718 9 ай бұрын

I see too many guys scewring around with these valve adjustments and end up burning out a valve. Especially the exaust valve. I leave them alone unless absolutley needed.

@mg8718 9 ай бұрын

I generally dont screw with the valve adjustment unless absolutley needed which is almost never. For plugs, use only NGK and a tiny dab of antisieze and hand tight only. (No torq wrenches). Replace plugs and coils as a set every 2 years.

@K03sport 7 ай бұрын

this engine eats plugs every 2 years? the hard exotic metals (platinum/iridium) should last 7-8 yrs based on 12k/yr. Are these just plain copper plugs you are talking about?

@mg8718 7 ай бұрын

@@K03sport Irudium plugs.

@mg8718 7 ай бұрын

@@K03sport 7 to 8 years? What are you smoking?

@nknasi 3 ай бұрын

@@mg8718 you're the one smoking something if you think iridium plugs need replacing every 2 years.

@urielanderson3159 9 ай бұрын

This helped me determine that the mini was the one I wanted. Thank You

@Zoe77777777 3 ай бұрын

same.

@andrew30m 9 ай бұрын

Very helpful

@Mrkrupps 10 ай бұрын

This was helpful

@belka0014 10 ай бұрын

Do you have an instagram account for those builds ?

@duncanholman9034 10 ай бұрын

Thank you so much for this video!

@ricoletta 10 ай бұрын

this is great, thanks!

@JSSBBB 10 ай бұрын

This really helps me choose. I wear a medium helmet, so I’m going with the mini. The pro sticks out way too much.

@brilliantstudio 10 ай бұрын

I really appreciate clear calm naming of parts. Thank you!

@Chrunchmunch 11 ай бұрын

What size socket?

@christopherwynn-realtor8616 11 ай бұрын

Great job, great pics and illustration/explanation. Thanks! 😉👍🏻

@TheRenemeng 11 ай бұрын

what if they both slid out? i was changing the hubs on my 2013 fit and this very thing happened just today when i went to put the hub assembly back on on both the driver and passenger sides.

@TheRenemeng 11 ай бұрын

also does the car need to be on?

@zedizdead 11 ай бұрын

I've spent 4h trying to figure that out when replacing the lower control arms in the past, such a pain

@CTTH100 Жыл бұрын

I measured 10" behind ear to ear and regular size is very tight. No gap between the band and head, device is actually sitting in my ear. Box has no indication of Mini so I assume it's regular.

@Hebrew_hammer52 5 ай бұрын

Same idk why but I ordered the regular and they fit super tight to my head. If I move my head up they slide into my ears. Did they accidentally send me a mini but in a standard size box? Pretty disappointed

@CTTH100 5 ай бұрын

@Ethan_Lipsky I'd say no, they didn't send you one in wrong box. I went to my local BB and the regular size is quite small and tight like the one I received. Can't even imagine what the mini is like.

@Hebrew_hammer52 5 ай бұрын

@@CTTH100 well shit. Idk if I should just return them or try and deal with it. I work as an engineer on ships, so I wanted a pair of headphones I can still wear earplugs with but I’m worried I’ll get too annoyed with them constantly moving out of position

@CTTH100 5 ай бұрын

@@Hebrew_hammer52 I returned them because they did not fit as they were supposed to. They ended up in my ear canals versus in front of the ears.

@Hebrew_hammer52 4 ай бұрын

@@CTTH100 did you end up going with a different brand or pair?