a.co/d/gTXsp1X

Voice over wasn't the greatest. It's t tap connectors. Wirefy 120 PCS T Tap Wire Connectors - Quick Splice Wire Connectors - for Low Voltage Usage - Quick Disconnect Wire Taps - Red 22-18 AWG a.co/d/2U4ziO5

@@GapEmBoyzEnt just wire them like I did in the video.

From the pink wire on the harness 6:38

@@blownfusegarage Thank you. I may just have a faulty head unit, I have tried every different combination on youtube.

Enkei RPF1

Yes you can. You just need to tap into the power wire for the headlights

Yeah that can be done. Just find a power source that is powered when you have the ignition switch on.

www.oreillyauto.com/detail/c/metra-electronics/metra-electronics-radio-installation-kit/met0/957899

I updated the links and left the part numbers in the title for each link in the description section in case the links get messed up again.

Trim

Yes

What do you mean program the radio?

My radio have no signal and when I do a search it for channels it comes back empty. Thanks.

Sounds like an issue with your radio antenna

Check your wiring connections. Make sure they are all tight. Sounds like a connector might be loose

No that's not normal. You may want to get a warranty swap done on the radio. I doubt it's from how you installed it, probably just a bad unit.

No it shouldn't prevent the camera from working. Only thing I can suggest is to double check your connections for the camera and make sure the yellow rca cable from your camera is connected to the "camera in" connector on the back of the radio harness. Also make sure the red wire attached to your yellow rca connector from the camera is connected to the violet wire with the white tracer on the radio harness

@@blownfusegarage thanks for the quick reply! I messed with it all night and now can't get the camera to engage when put in reverse. Here's what I tried and just left it accessible in manual mode for the mean time. Any insight as to why it won't engage with the shifter? "Red" is the wire coming off the RCA. • Reverse input to "red" - no signal detected (no screen) • Reverse input & rear cam pwr to "red" - camera stays on and won't let me toggle through sources • Rear cam pwr to "red" - camera works only when selected • Rear cam pwr to "red" & reverse input ran to + of reverse lights - camera works in manual only then stays on when selected. Shifter still doesn't work.

Not to sure why it's not working. It should work the way I showed it on the video.

The blue female connector doesn't plug into anything on the 01-05 civic. You just leave it unplugged

@@blownfusegarage awesome thanks for the video and the reply.

@@blownfusegarage so what did you use to connect it to the ground?

I used a butt connector and added some 18 gauge wire with a ring terminal at the end to put over the factory ground bolt.

You have the yellow cable plugged in on av in?

@@blownfusegarage no I have it connected to video the camera works but just doesn’t change unless I go into AV 1

Your harness has two yellow connections on the back. One is video in and the other should be camera in. Connect the yellow wire from your rear view camera to camera in on your radio harness. When connected and on radio, Bluetooth, or car play the screen will switch to your rear view camera automatically when you put the car into reverse then will switch back to the screen you were on before you went into reverse.

@@blownfusegarage when I put it in camera in my screen won’t change to the rear view camera at all

Only thing I can suggest is double check your wiring. Yellow cable from your camera should be plugged into camera in and the red wire thats attached to the camera cable should be connected to the violet wire with the white tracer which is labeled reverse +

It's an LX

Not original. Car is a DX so it has aftermarket.

Yes

You can run car speakers through a 4 channel amp. You would just need to run the speaker wires from the factory side of your radio harness to the 4 channel amp. No subwoofer needed

@@blownfusegarage awesome thanks for the info!!

?

Get a rca extension cable like this www.ebay.com/itm/25FT-RCA-Audio-Cable-Single-Extension-Composite-Male-to-Female-Plug-M-F-/233879633123?mkcid=16&mkevt=1&_trksid=p2349624.m46890.l6249&mkrid=711-127632-2357-0

I thought that's what the video is for, jeez....

I removed the center console because there are bolts underneath the radio and ac controls you need to remove to take it out. And I removed the ac controls so I could tighten the screws on the side of the radio to the radio bracket

The 5 speeds are different

Yes the radio should be off when you turn your key to the off position. Did you use a harness adapter or is it directly connected to the factory harness?

Yeah its long enough.

There is a plastic trim between the top of the seats and the back window where the rear speakers are mounted. You put your car key in the lock cylinder for the seat release which is on the same panel between the rear speakers. Then turn it to which side you want to move down and at the same time pull that section of the seat down

Glad it helped you out.

@@blownfusegarage my player does not have the purple with stripes cables. How can in find which cable to connect the red from the video cable ?

@cocho2deguerrero if it's the same radio in this video it should have it.

J message me on Instagram. So I can try to help you out. I'm @ blown_fuse_garage on instagram

@@blownfusegarage there was a fuse I found in the motor fuse box labeled “back up” I replaced it and that’s what got it going.

Song link is in the description

www.amazon.com/dp/B079777QZW/ref=cm_sw_r_cp_apa_glt_fabc_PJKFWEKEPDRYHV5K4G1R?_encoding=UTF8&psc=1

I want the yellow ones like u got bro

@@saintrobles9639 my friend tinted them with this www.amazon.com/dp/B017MWRME0/ref=cm_sw_r_cp_apa_glt_fabc_H7N8P65FPTAWR59RN5Z5