I cant believe you didn't say which wire goes where. Ffs.

How is that light getting a Neutral? L+N into the first switch, then 3 switch conductors between the next switches, and a feed from the last switch back up to the light..

Id love to replace a swith with an outlet but as far as i know from google 😅 its impossible due to the fact that a switch doesnt have a cpc wire. I need video on this topic.. please

I cannot find a video how to replace a light switch with an outlet. Is it possible to do ?

This is actually illegal in my country😂

Thanks

Probably being really dense here, but I don't understand how doubling the length of the circuit is connected in parallel? surely if the circuit length were just doubled, so connected end to end, the circuit is series?

Edit when he said 0.05 he meant 0.5ohm for figure of eight

do u do classes as in a classroom

Great video

GangSter 😎

Squirrel cage......It does not look like an electric motor to me. Lol

epic video thank you

Great content. Thank you.

We've got that sort of bulb in our kitchen hanging lights, ours cost £15 each 😮😮😮😮😮 Can't eat at the breakfast bar they overhang either as I'm too tall 🤦 Bloody wimin and their needs 🤣

That's somewhat counter-intuitive - presumably a very long string of tiny LEDs implies little or no lossy electronics ... and low power LED lamps are often more efficient as well as longer-lived... EDIT:- just spotted the "amber glass" bit ...

How frequent should landlords test RCD in a HMO?

That is a bulb for effect rather than practical use.

it's not really a g, after theygot rid of regular tungsten filament bulbs the old scale became irrelevant so they made a new scale that essentially just the most efficient end of the old scale stretched out. it's a 2.5w bulb. at that point the efficient or inefficiency of an led bulb were talking fractions of a watt difference.

Will try that tomorrow nice one 👍

Use ferrules

🎉BINGO BABY 🎉

Bloody marvellous. Thank you very much 😂

Great video 👍🏻

Super ❤

A few months ago you posted a video saying that level2+3 2365 exams were going to be ended which would stop adults from becoming an electrician as t-level courses would be for 16-19year olds. Is this still accurate?

Very well explained 👌

We were taught CRIPPLER in college to distinguish which polarity test you would do first.

We’re do you get these

Would the adjacent property also have 2 cables going into the cut out? Or could they have 1 suggesting they are at the end of a loop but could be forgiven for thinking they’re not looped as they can only see one cable?

Excellent Gary.

Thanks Gaz. Assessment tomorrow

What's wrong with using a light switch for main isolator?

Can you extend the cable on these to feed the main earth to a dwelling ?

Housepital Reception Electrical circuit diagram

Rubbish, magnet is very weak keeps falling

How come when its three phase and neutral,its just a 3 pole and not a 4 pole that is the requirement

stating the obvious surely ? should be an overcurrent protective device really....regs are lacking.

thanku brother ❤

Best and most straightforward explanation i have found thanks 👍👍

it's there any special procedure for using the line breaker? not sure if it was just a coincidence but I used the one in my beaker box so I could remove a dodgy circuit off of bell wire that someone had put in years ago, and it seemed like certain electronics around the house broke shortly after. not sure if I was supposed to turn all the other breakers off to prevent the possibility of a power surge? or if it was just a coincidence

The pigtails would still be live I'm guessing?

please do not educate people by using soft cables without ferrules. it's 10x more important than torque.

I've never heard them called "joint boxes" before. Aren't they called junction boxes?

The wire strippers are designed to strip the Live/Nutrual at the same time... you did them seperatly which is slower