I had same problem and I know this video was published 2 years ago but your tunes are the far left wher their is no numbers so you go all the way left and your at tune one your sticker is in the wrong position
@JesusPerez-ov7vq7 ай бұрын
I had the same problem with my lly but I just re adjusted the sticker
@Mudhunters909 ай бұрын
This is transfer case chain. I just replace my prado 90 transfer cace mostly its happen over use 4L
@lilsnoop1019 ай бұрын
Need to changed fluids
@ajgattarello64249 ай бұрын
Do you know the size of those hoses ?
@user-uc9yq3ij3k10 ай бұрын
Flexplate. Especially if getting ticking once warm and tick sound and frequency increases when you shift auto to D R etc
@nordicpride970811 ай бұрын
Sounds like a sloppy chain. Remove the fill plug and make sure it has fluid. If not probably a bearing. A lot of folks rarely change the fluid and most def never check the level. Best of luck
@grayjd2 Жыл бұрын
Does it drone?
@caspercanulracing Жыл бұрын
Super cool! How much power are u making ? For street / track / drift?
@malick469 Жыл бұрын
Did you ever figure this out
@solluna2155 Жыл бұрын
The hear the noise more when moving forward for example like changing to parck to drive and reverse or stoping on red light and then accelerating ?? I hear a similar noise on 3rd when i accelerate buts goes away after getting to speed.
@BrushyZeusАй бұрын
Same issue, did you figure out what it was?
@nachos4018Ай бұрын
@@BrushyZeusI was hella low on oil and realized I had a leak, made sense since it got worse progressively. Just dropped it off with my mechanic to check if there was any internal damage/ fix the leak
@treysmith7818 Жыл бұрын
Hey homes where did you buy the front A arms from
@agentlythinkingleo9243 Жыл бұрын
You forgot about the washer but thanks a million, very much helpful information.
@generalgravy4273 Жыл бұрын
2wd?
@georgemanley6421 Жыл бұрын
Putting that on a car makes it sound awful I can fart and that sounds better
@cristiancamacho7876 Жыл бұрын
What is the cheat sheet? What does each tune do?
@capitalsoleztv7117 Жыл бұрын
Rims & tire sz ?
@nickz49932 жыл бұрын
Great sound, the canister looks low, did it scrape at all?
@koromaniapoto71842 жыл бұрын
Did it stop the smell ? I have a 05 wrx sti and when I take it for a little drive and stop, that's when that smell comes in. Could this also lead to miss fire ? Sometimes when I put my foot down it miss fires, like I'm running put of gas. Could this be the reason ? Please help
@kingzfa Жыл бұрын
You have a fuel leak also you're fuel pump needs to be replaced so you can get better acceleration Just replace the cylinder pump that's in the fuel tank located behind the back seats
@GregLatronica2 жыл бұрын
Hear me out. I had a noise that I was trying to figure out for over a year . My Xfer case makes the same noise, shop said it was a bad Xfer case bearing. Turns out it wasn’t the Xfer case at all. It was the little axle nut covers on my front axles vibrating around.
@reprisal1051 Жыл бұрын
Did it make a rotational scraping noise?
@jdawg37122 жыл бұрын
Lube, lube & more lube. Jest like a dried out old woman, lube her up n she'll be good ta go!🙃
@gamenessfirstinc.20972 жыл бұрын
do you know any good a arms swap for 88 lt250?
@k_watts2 жыл бұрын
Same sound coming from my 2004 Infiniti qx56
@gior53172 жыл бұрын
Sounds great! Been looking for a catback and I’ve been thinking of the Invida N1 but not sure i like the price lol and this one sounds really similar for much less $$. Will this fit a stock 06 sti or do i need to get an adapter and donut gasket?
@somethingfishy18022 жыл бұрын
Looks dry af, dude pump up the grease fittings. My was making that noise before lubed up.
@dan8426 Жыл бұрын
Has nothing to do with those. Those are for the ujoints which look fine. That's inside the transfer case
@MTBnation2 жыл бұрын
31mm
@juanrepollet26232 жыл бұрын
Same noise on my 96. Tore the case apart and found zero issues with bearings. All spin smoothly and quiet by hand. Chain has minimal slack. At this point I think I’ll just find a used unit.
@somethingfishy18022 жыл бұрын
This is the noise of unlubricated U-joints. Pump up the grease fittings ( zerk fittings )
@dan8426 Жыл бұрын
@@somethingfishy1802 no it isnt
@Mudhunters909 ай бұрын
If chain and transfer case ok you can check front and rear diff free play
@chasemcclary88612 жыл бұрын
do you like this shifter my trans with my old ass cube shifter feels awful thinking of the drift motion with the extended housing any thjing i should know?
@hunterkipp74792 жыл бұрын
Fill the fluid up
@alnorth6122 жыл бұрын
Where is Svetlana ?
@ALores6692 жыл бұрын
What are your wheel specs
@chrisjoachim70402 жыл бұрын
I can smell it just watching this video.
@Kyle_gallegher2 жыл бұрын
After my rebuild I couldn't get the arm to face left as much as was before I tore it down and now I dont get why. Also my clutch lever need to be replaced it has no more resistance
@arunc19583 жыл бұрын
Did this change the offset of the wheels
@daleduro65053 жыл бұрын
If you are using a stock Yamaha wheel then it will look a little sunk in. You can put some spacers in or just get a low offset whee to fix it.
@luda007693 жыл бұрын
Thank you Dale! This is exactly what I've been asking local shops and they haven't been able to help
@NoLimitsFunGarage3 жыл бұрын
I'm having the same issue on 90 series prado
@doomkid023 жыл бұрын
The r350 rotors don't require you to redrill the bolt pattern. Running that current setup.
@agent50cc3 жыл бұрын
The answer to the problem is the reply to Mike hunt
@machinegungaming7713 жыл бұрын
That is easy for me to see that is a non venomous garter snake the bite might hurt for a bit but you or your kids would be perfectly fine just make sure that the bite does not get infected and if you kill it then that will make rats come and when there is rats there is non and venomous snakes
@lpaulman323 жыл бұрын
If you take the knob off and then behind the knob there’s a little washer with a hook on it it should be positioned between five and six
@daleduro65053 жыл бұрын
Yes thanks Paul. After I removed it I noticed that it was clocked incorrectly. I corrected it and now have my tunes on the fly.
@mr2loverboy3 жыл бұрын
Honestly the EJ sounds good no matter what exhaust. Makes me regret dropping $800 for the invidia N1😂 anyone interested in buying an N1? Lmao
@mynameisjeff15183 жыл бұрын
Still for sale ?
@mr2loverboy3 жыл бұрын
@@mynameisjeff1518 sold the car instead lol
@michaelvasquez39953 жыл бұрын
Nice i always knew a 17 cal can do work not bad i usually use 17 only for feathers but i know for sure those magnums especially gamos 1650 fps magnum can take coyote and possum out with the right pellet now a days how bb guns have changed lmfao
@Sean_Bolkcom3 жыл бұрын
Dale duro dijo arturo
@sabpac4593 жыл бұрын
and i thought mine was the only one pouring water looool
@jdmcivicsir23 жыл бұрын
What all did you have to cut and change to make it fit properly?
@JohnB-km2eo3 жыл бұрын
Mudding??? 😂😂😂 u must be from the city! We call those mud puddles. LAME!