thank you for all those videos, gives us a great view on what parts to upgrade in order to make it smooth. though I am still unsure about my setup. im on a 5800X with 16GB RAM (3200 CL14, cant get it higher on my B350 Board) and RTX 3070. Im on 1440P but performance is meh. MSFS and CS2 are my main games with a few single player games on the side. Since MSFS and CS2 are both CPU bound - would it make sense to upgrade my rig to a 7800X3D first and keep the 3070 for a few months (to make it a 5XXX card in the future) or keep the AM4 setup and hop onto a 4070tis now? I know ill eventually upgrade both directions, just cant do it now. Going AM5 would also finally give me 32GB RAM. But I dont know if I will make good performance gains keeping the 3070 on 2k resolution. :/ Mind helping me out? need a rationally oppinion :D chronical overthinker o7
@AirNOTT2 сағат бұрын
Best place to start would be enabling developer mode in the sim and then turning on the fps display. It should tell you which component you’re limited by. If it says limited by main thread, that’s your cpu. At which point you could open task manager and see how much usage is being put on your GPU while cpu limited to get a sense of how close to edge your GPU is being pushed while cpu limited. From there you can estimate how quickly you might become GPU bottlenecked if you introduced a faster cpu. For example, if you’re GPU is at 90%, upgrading to a quicker cpu will make you GPU limited very quickly. In my case, my 4080 super is at around 50-60% at 4K with frame gen enabled. So room in the tank should a new cpu is introduced (9800x3d maybe, when / if it launches)
@mxyoo22Сағат бұрын
@@AirNOTT thanks for the rapid response! im MainThread limited like 95% of the time. there is an occasional GPU limited frame. GPU utilization never exceeds 50-55%, CPU is 40%~ (it varies a lot!) during a normal flight (using FBW A32NX). If I put DLSS on quality and increase some setting to ultra, the GPU utilization crawls towards ~60% (but it varies too, its usually way below 60). Cruising altitude is okayish smooth, there are a few stutters but its "alright". Once im on an approach, it feels apart the closer I get to the ground... CPU frametime is 15-20ms when crusing, and 30-50ms when landing. GPU is like .. 8-10ms? I can have 45-50fps in the air, and then on landing it can drop down to literally 10fps.. On most Triple AAA games im obviously at 100% GPU, so there wont be a huge gain I suppose - though ive seen some comparisons between a regular Ryzen 5XXX and 7800X3d and there is always a good boost in FPS, even if you were GPU limited before. its tough cuz I feel like overall the 5800X and the RTX 3070 are decently balanced. But I know pushing 2K, especially on newer titles, while wanting a smooth experience pushes it to its limit. So ill have to upgrade both eventually, just not sure what would benefit me more. I guess if I let it come down to games, I'd prefer a smoother experience in CS and MSFS as those are my main games. The Triple-AAA games im not so eager to push it to graphical limits yet. btw - introducing 5800X3D is not an option. If I upgrade the CPU direction ill go all-in on AM5.
@austinmario799 сағат бұрын
Smooth landing
@ryanxtravels11 сағат бұрын
hey man! been a while since ive joined ur streams
@jayvalero299914 сағат бұрын
puuuuuuuuullllllll uuuuuuuupppp
@ZivkoSkobic23 сағат бұрын
"A bottle of pepsi, coca cola glass... i don't give a damn" vibes
@TonyChurch11223 сағат бұрын
That’s nothing. I land Boeings with my keyboard.
@speedrace95Күн бұрын
You animal
@ZZ24667Күн бұрын
Wait till you see me flying with a steering wheel
@stevem4005Күн бұрын
LOD at 200 is way too high for most people, and will bring many systems to their knees.
@Flywithcraig2 күн бұрын
Great video! I love the way you teach, you have a great way of delivery. Could you do a GSX pro tutorial please? I've tried and tried but I just can't get it to work. I've downloaded profiles and all sorts and I'm just so lost. I know I'd learn it from you!
@OmegaSimPilot2 күн бұрын
Just got an Ender 3 v2 for free from a coworker this past weekend and this is absolutely happening! Thanks for the tutorial and info!
@AirNOTT2 күн бұрын
Wow! What a steal!! Good luck with it
@Ginuwine-kx2iv2 күн бұрын
Question, will that setup support a resolution of 2160x9600 at the same settings in MSFS?
@AirNOTT2 күн бұрын
I doubt it. Maybe with DLSS upscaling? Would have to test it properly to be sure
@ericdecker77712 күн бұрын
Thanks man! This wasn't perfect for me, but it got me close!
@AirNOTT2 күн бұрын
Awesome!
@marklee14623 күн бұрын
vs coverage too broken
@nunugames3283 күн бұрын
Fly a boeing w an airbus stick
@Oven973 күн бұрын
There’s no throttle decrease for me how do I add that?
@tommy-pro123 күн бұрын
before I used bought a Boeing yoke I would fly Cessnas and the B747 with Airbus yok😅
@Luca-mk9zc3 күн бұрын
Lots of people have done that
@tommy-pro1220 сағат бұрын
@@Luca-mk9zc yea
@Lendercl18 сағат бұрын
ive been flight simming with only an extreme 3d pro since 2014
@youhavenoswagyoumofo3 күн бұрын
What graphic settings using?
@Peter1975Meulebeke4 күн бұрын
On takeoff perhaps use a derated setting, and TOGA? I saw you go above 100%, and switch autothrottle after takeoff... And maiden-flights should not be between 2 of the busiest european airports....
@ZZ246674 күн бұрын
The gatwick ground controller is really friendly
@AirNOTT4 күн бұрын
Yeah they’re good folk at Gatwick. Tbh I’ve found them all to be very good and understanding.
@supressorskid1235 күн бұрын
Can someone reply to this comment with a script of how to request push and start ect and when to talk to atc?
@AirNOTT5 күн бұрын
Google VatSim cheat sheet
@supressorskid1235 күн бұрын
@@AirNOTT thank you so much man I’m still watching this video. Great content!
@Fredopia_TTV5 күн бұрын
No flare?
@chittychad185 күн бұрын
Doesnt work with 0-100 axis
@Edge6D5 күн бұрын
I have a 3070 with triple monitors, at 1080p, with all setting set to maximum like yours, and get a decent 35frs, the gpu is used at 99%, the cpu only at 25% when I install the mod, the frame rate drops to 23, DEBUG FRAME RATE IS 11, GPU usage only 40%, cpu 18%. it looks like hardware acceleration is not active, and these framerate stay the same with only one display. anyone else have these issues ?
@nunugames3285 күн бұрын
remember me when u get famous
@wild_cumulus_cloud5 күн бұрын
Do you get ghosting engine running textures with any of these methods?
@user-gn9pk1cb3g5 күн бұрын
How does the ATC work? Is it someone overseeing the full game network?
@AirNOTT5 күн бұрын
It’s real people controlling various airspaces. Not everywhere has coverage, depending on which controllers log on. In that instance, pilots try and manage things amongst themselves on a frequency called “Unicom”
@PeaShooter335 күн бұрын
How about ai traffic? Still the same ol bunching and constant go arounds?
@AirNOTT5 күн бұрын
VatSim 😉
@PeaShooter335 күн бұрын
@@AirNOTT hmm. I enjoy digital spotting, using AIG schedules etc. What i meant is like the way ATC works in the sim with AI. I feel that has always been an underdeveloped part of the sims.
@paulrubens30486 күн бұрын
showing the SAME picture TWICE is not what gamers are after when it comes to framerates.
@ayze23416 күн бұрын
nice flight man
@dismaldunc6 күн бұрын
thank you so much for this, as a noob I had no idea what settings actually did, i copied your settings using TAA and frame gen and im now really happy with the result.
@skykingron6 күн бұрын
Great job on the comparison appreciate the time you took to it!
@AirNOTT6 күн бұрын
Cheers Ron! Glad you found it useful 🙂
@treloarw6 күн бұрын
for some reason the generated list is not seeing my installation of flight simulator.
@GaryGoldGoldGold7 күн бұрын
Needs a proper livery I think :hint :hint
@AirNOTT6 күн бұрын
Yes, sadly I think you’re right!
@loabical7 күн бұрын
If you're nervous about using VATSIM, I highly recommend checking out your local VACC. I recently joined the Dutch VACC and spent a few hours observing how ATC operates across different frequencies. It gave me a much better understanding of the process. Now, I'm waiting to earn my S1 rating so I can become a controller myself. I believe VATSIM can be stressful because you're unsure what to expect from ATC. Since I started using BeyondATC and observing controllers, I've become much more confident on the radio. Ohh, by the way. Do you have a discord server? I’ve been watching your videos and would love to have a chat from time to time 😄
@mrc74787 күн бұрын
Sod the landing, you've got the pilot's voice perfect.
@AirNOTT7 күн бұрын
Haha I’ll take it!
@BoganGames-107 күн бұрын
Great vid, this literally transformed my game. Love your stuff
@AirNOTT6 күн бұрын
Thank you!!
@llVoidZ7 күн бұрын
My lossless scaling crashes my whole system and then my pc force shuts down instantly :/
@progamersplay47168 күн бұрын
Quick question is it better to use a Joystick with the a320 as I have been using a honeycomb but landings are no less than 270 feet per minute . I know is acceptable but It gets hard to land with precision
@barneywalker60628 күн бұрын
So with Lossless Scaling say now i am around 45-50FPS on high settings, If i use this can i say get 45-50FPS but improve my graphics settings?
@123y.z8 күн бұрын
Aku dari Indonesia : tstagagydgegsysgevuduegehdueggaysgeg
@mythicstreamz34978 күн бұрын
Hopefully Vatsim will connect with 2024 😊
@TheAvationKid9 күн бұрын
Hey, How do you record these shots? I assume you use OBS, but was is your settings? Maybe make a video ahout this.
@stevengilbert51149 күн бұрын
I could never fly on vatsim lol i can hardly understand what atc says 😂
@JYang3659 күн бұрын
Hiya, how do you do the hold button, then increase power one? Thanks.
@Ado22349 күн бұрын
Will it work with 3070 gaming laptop???
@filmingle62279 күн бұрын
This must come with a cost of high cpu intensity right? Pls reply if you know thanks