Пікірлер
@MinhHDang 5 ай бұрын
Thank you for very nice video
@staples932 2 ай бұрын
Most welcome 😊
@cgclyde9040 5 ай бұрын
*promosm*
@alexsmelov8855 7 ай бұрын
Hello. You have an interesting method of tightening the nuts on the rotors. Do you have a LinkedIn page?
@staples932 7 ай бұрын
Hello, Yes It's a special Rotor nut spanner I do have a linked in page
@rafpange Жыл бұрын
Screw compresor chiller N250
@ajm5969 Жыл бұрын
Nice work smacking coupling on with hammer, pity the thrust bearings and seal face
@staples932 Жыл бұрын
Coupling basically slid on, a few soft taps with a soft face hammer with anti-seize really going to cause more stress on the thrust bearings and seal then the direct drive motor kicking it in the guts to start up & then drive the rotors into said thrust bearing at the kinds or forces and pressures found inside these during operation sometimes 24/7? I’ll tap that coupling on all day 👍🏻
@ajm5969 Жыл бұрын
@@staples932 fair enough. It’s just not good practice , thought Gordon’s had higher standards
@staples932 Жыл бұрын
@@ajm5969 Definitely not if there’s any resistance to it going on at all. This one fit nicely.