Mycom 250L Screw Compressor Overhaul (Ammonia Plant)

Complete Overhaul on a MAYEKAWA / MYCOM Compresso Compressor Package
Music: www.bensound.com

[@MinhHDang]

Thank you for very nice video

[@staples932]

Most welcome 😊

[@rafpange]

Screw compresor chiller N250

[@ajm5969]

Nice work smacking coupling on with hammer, pity the thrust bearings and seal face

[@staples932]

Coupling basically slid on, a few soft taps with a soft face hammer with anti-seize really going to cause more stress on the thrust bearings and seal then the direct drive motor kicking it in the guts to start up & then drive the rotors into said thrust bearing at the kinds or forces and pressures found inside these during operation sometimes 24/7? I’ll tap that coupling on all day 👍🏻

[@ajm5969]

@@staples932 fair enough. It’s just not good practice , thought Gordon’s had higher standards

[@staples932]

@@ajm5969 Definitely not if there’s any resistance to it going on at all. This one fit nicely.

[@alexsmelov8855]

Hello. You have an interesting method of tightening the nuts on the rotors. Do you have a LinkedIn page?

[@staples932]

Hello, Yes It's a special Rotor nut spanner I do have a linked in page