I have got to redo mine got 40years out of it do you not need to prime the old roof first I used boards last time that had bitch on them
@RickyBeattie3 күн бұрын
Wtf is he doing
@ogg14181Ай бұрын
No bueno
@suada21002 ай бұрын
مصري
@map200132 ай бұрын
I don’t know I’ve been roofing 30years now and do a very lot of tourch down rubber and I have to say that’s the first time I’ve ever seen somebody do it on their knees
@pureblood64923 ай бұрын
fake roofer even faker englishman.
@ajelicits34356 ай бұрын
ok, you also have to cut a 45% angle on your pieces you are going to connect onto each other. it allows the entore rolls to stay one size instead of doubling it up and created high spots. he's also wearing shorts, wtf???? he's not getting any rrof down the way hes doing it, his knees would literally burn if he was kneeling on a freshly torched piece or even on a very hot day the cap gets so hot even with clothes its too hot to kneel on.
@ajelicits34356 ай бұрын
use a metal puller and preheat the laps a little ahead of time if you want a bleed. dont walk or knell on your rolls, stan behind the roll and pullit towards you. If you work fast the rolls you are currently kneeling on would be far too hot still and would leave marks. Maybe it doesnt because you only heat the laps which is incorrect.
@alexgreig35983 ай бұрын
Must have asbestos hands and tough knees kneeling on that mineral!
@ajelicits34356 ай бұрын
this is what you call a lap torcher. you have to heat the entire roll. I could get the right angle and ppull that up not long after you torch it down. if properly torched you cant.
@kevinyardley71936 ай бұрын
No roll bar, cant control the spread of bitumen across the roll, it must all be fully adhered
@CentralNicon6 ай бұрын
He doesnt have e to shave his knees anymore
@graemepae1008 ай бұрын
History states that he is still torching this on in 2025 😂
@ajelicits34356 ай бұрын
hahahhahaah
@RicardoRivera-eg4eu8 ай бұрын
Chi gon primo asies
@deansmithnow8 ай бұрын
what a muppet. No PPE/Gloves knee pads - utter cowboy
@williammcgeehan34249 ай бұрын
😳😳😳😳😳😳😳😳😳😳 Good grief !!!!!!!!!!
@robert_costello9 ай бұрын
I swear, you would’ve been fired 30 seconds into this video. That’s a 400,000 BTU torch and you decided to go with your bare hand?
@ajelicits34356 ай бұрын
the bare hands part is not even the issue here, it's literally everything else hes doing including wearring shorts. Ive roofed over ten years and rarely use gloves when torching, a small burn on the hand is nothing, open shorts on the other hand is insane. if hot tar splashes your legs i feel sorry for you. also the way he torched the roll was all wrong.
@AlMai222Ай бұрын
Who cares about that, where’s the base layer ?
@Jim-s7l1s9 ай бұрын
U sir are a complete bellend. Has to be the worst one on the tube
@elmermunoz7910 ай бұрын
Cuanto por squares
@andreamelardi619610 ай бұрын
ma cosa stai facendo?
@alistairlaird388311 ай бұрын
Cowboy
@ryanlockwood157 Жыл бұрын
Why is he using a scraper for the lap underneath 😅 what ever happened to using a roll bar? I'd have done 3 jobs by time he completed that run
@MdYeasinArafat-ob4nv Жыл бұрын
I dont that's work
@hectorvillanueva2464 Жыл бұрын
Mala técnica
@hectorvillanueva2464 Жыл бұрын
Necesitas 👢 y guantes
@user-1980_fahad Жыл бұрын
لم يتخذ اي شي من ادوات السلامة. والجودة
@sylvainrousseau3349 Жыл бұрын
🤡
@lupe4980 Жыл бұрын
You should be ashamed, thinking you where going to get away without anybody roasting you 😂
@travissmith3720 Жыл бұрын
Good job. Most roofers do slop jobs. But it would be easier if you had gloves , a bar , and knee pads
@Ser_Yozha10 ай бұрын
Это плохая работа. Он вообще не умеет работать.
@bartoszm6325 Жыл бұрын
This was painful to watch.
@ivogrinvalds8698 Жыл бұрын
So bad work
@leeandsarahsworld8091 Жыл бұрын
Fully licensed in doing it the wrong way 😂
@johnmuir8930 Жыл бұрын
Cowboy
@mjh5437 Жыл бұрын
What a total div,he hasn`t got a clue,that won`t last 20 months,never mind 20 years.
@callumgoodall7272 Жыл бұрын
That ain't stuck where did they find this fella 🤔
@whatyousaidbud Жыл бұрын
For anyone criticising, this is how work quality evolves when customers always choose the cheapest quote.
@kevin_e90 Жыл бұрын
I love how he keeps burning his fingers 😂 like you had a trowel in your had 2 mins ago idiot 😂 doesn't show the complete video either, because you already know the rest is terrible too
@sukhdevhayer4992 Жыл бұрын
Shocking felting!
@JuanElBautista89 Жыл бұрын
Kneepads, gloves, safety glasses, long sleve shirt, pants and a fire extinguisher
@jonasmagnusson2099 Жыл бұрын
You can’t work as a roofer without gloves!
@alanredmond6646 Жыл бұрын
No gloves wearing shorts maybe high performance felt not labour
@michaelwoodward780 Жыл бұрын
The London way ey , that mineral looks nasty reminds me off a ciggy paper
@roryb3013 Жыл бұрын
What the fuck is he doing 😂😂😂
@tylesveque23732 жыл бұрын
Spot welding lol I think it's time for me to post videos
@paulmecock12 жыл бұрын
Wow I’m not mr health and safety but he is a accident waiting to happen
@johnboy5422 жыл бұрын
Should be called john wayne roofing london
@nelgchannel96612 жыл бұрын
lol
@makingbreadnotcrumbs2 жыл бұрын
i hope he isn’t a foreman cause honestly I’m concerned for his crews safety.
@kevincasson98482 жыл бұрын
No gloves, he's burnt hosing tube. He should be rolling with feet. He's too slow felt not sticking properly He's a cowboy make no mistake!!@