Is there any reason you would not want to try one of our waste gates that is designed, engineered, manufactured, assembled, and supported here in Michigan?

Thank you

Hi I have a Chevy Colorado 2007 and I'm having problems with the ac/heater I put the air on and it flips to heat but the speed on 3 or 4 is not working can you help with that

how about the actual switch in the dashboard

I just bought a used Colorado with this exact problem, thanks so much for this !

Not a very good view of the job

Hey, thanks for the video. If I've understood correctly, there's no need to unscrew the screws underneath the bumper to remove it completely. But is it possible to spread it as you do without removing/damaging the headlamp washer covers? Thank You.

part number for wire harnees and relay

Thanks Mine Lexus RX350is showing me p0304 cylinder 4 misfire detected. Does that also me that the coil is bad also?

I thought the firing order is 1,3,4,2. ?

Thank you Sir !!

How's the supercharger whine comparing to the jlt intake?

Ok..PO304..Cylinder 4 Misfire..If it is a coil pack..Yes change it...but pull the spark plug out of #4 cylinder to inspect..Good idea to do a dry/wet compression test as well....

Very important. LISTEN TO THIS... This Blower resistor is not grounded properly. Behind the air box is a bolt with 5 or 6 ground wires all hooked to this one bolt. Chevy didn't remove the paint, and there is no star washer there. After I replaced two resistors, I cleaned this ground, ...... No problem sense ... works great. ALSO behind the battery box is another ground, same thing with five wires to it, and this one is the ground for all the pass code stuff, after I fixed that, seems my colorado starts every time 2007... I found this from another brother on utube, and thought to pass it on .... tell me if it works for you. Stan from Hawaii

If I get a bad coil I replace them all, I'm DYI and don't want to get back in in 6 months.

My 4 cylinder only misfires during start and stopped on drive.

Just bought a 2005 ram 1500 5.7l hemi need a badass exhaust setup any recommendations thinkin of Gibson exhaust and BBK longtube header dual side pipe

Will this help car start up

Thank you so much! The #3 never worked on my son’s truck. I looked at the harness and it was burnt out.

Take to car wash

What size socket to take out the coolant temp sensor?

Great short video. Thanks for sharing.

Thank you soon as my mechanic put my spark plugs in my engine light start blinking. Autozone had to tell me it was ignition coil4

The wheels on the right was repainted. It's just a little bit brighter.

'promosm'

🍀 Promo>SM

I have lth high flow cats and the oem muffler and my truck is quiet af wth

I get that error occasionally on my 2020 GT500. Sometimes, the switch actually sticks in the up position. I did get U0415 Invalid Data Received From ABS Control Module code, but thats it. Sounds like this may be my fix.

The wheels mine came with are a dark grey I'd love to see redone as clear-coated stainless or painted silver. This might be the way to go, rather than buying new wheels. Thanks!

With that many miles showing on the odometer, I’m so glad to see it’s being used for the reason it was built…DRIVING IT 🏁.

No coolant came out after sensor removal???

If you have spark plug problem this test not work

Thanks, i hope this works . I was told also that i may need to replace intake Camshaft Position Timing . Is this an option if the oil control valve doesn't turn out the light ????

Does this also cause a tick noise ? I have that code on a yuckon and passenger side makes a tiking noise

Can a bad one cause the car to shut down

Is the exhaust and intake valve the same? I keep getting the same code for both parts. Other code doesn’t fit my model. Got a Hyundai i10 2012

I have a 2014 chevy cruze .My car engine shake under red light but runs smooth.I took it to a mechanic shop i m told the Cylinder 4 is weak but they refuse to fix it they want me to replace the whole engine.

Thank you for your video! Newbie here... Got a 4-cylinder misfire code and panicked. Watched this video, went to the auto parts store with 5 minutes left. They had one more Cylinder Coil left for my car. Yada Yada Yada .. Kids get presents this year lol. Thanks again.

Well, this worked for about a month until it smoked the connector again. What is the root cause and how do I address that?

Just out of curiosity was it chiming at you constantly while driving? This is happening to me.

What's the next thing to check if what you said doesn't work? I checked fuses and relays. My guess is it would be the blower itself.

I have a blower that doesn't work on any position. Should I still do what you explained in the video?

Aren't the coils 1342? Number order

Where are the cutouts placed ?

You don’t have to take all that stuff apart just to replace the bulb. 🙄

Good but show us the rest how to troubleshoot shoot it completely like you said might be injectors or vaccum leak

my 05 just blew because i never checked that sensor

is that isopropyl alcohol or a different kind?

What size did you get 2.5 or 3.0

Must be a weak part, Ive replaced mine twice on my 04.