3 жыл бұрын
3 жыл бұрын
3 жыл бұрын
3 жыл бұрын
3 жыл бұрын
4 жыл бұрын
4 жыл бұрын
4 жыл бұрын
4 жыл бұрын
4 жыл бұрын
4 жыл бұрын
4 жыл бұрын
4 жыл бұрын
Пікірлер
@braut34 16 күн бұрын
This a sorry video didnt show how to do anything the really mattered.
@PhuongTran-it8wp Ай бұрын
People want to buy or not on product like this depends heavily on how hard the installation is!!! DUH!!! Where is the most important visual info of the back sensor or how it is mounted. I freaking wasted over 6' for a worthless video!!! Grhhhh!!!
@DamGodwin 2 ай бұрын
Can the sensors be calibrated with out using the the projector
@VCGhostHunter 5 ай бұрын
How much you charge for installing it on Honda Sedan like Accord ?
@thegrey8643 5 ай бұрын
I wish I could find a 1 minute video that just told me which two wires I could use to add a simple push button start but apparently the internet just isnt good at answering simple questions. Lead me here.
@JohnDoe-gk7xw 6 ай бұрын
Why would my drivers side be shorter than my right side on my 2020 Camry? It was fine until I took it to the dealer for an oil change. No dents or marks on bumper. Did you say the sensor starts at 28” inches behind the car??
@IADHDD 7 ай бұрын
What is the distance for the reflector's laser from the ground?
@alexmendoza8660 8 ай бұрын
have you completed the installation of the Boyd cell. can't find the video on it.
@airbagsunlimited 8 ай бұрын
The install has been completed but I'm not sure if there is video for that. If I can find the video, I will post. Thank you for supporting the channel.
@magdymohamed4795 8 ай бұрын
Perfect
@NinaRossBusiness 10 ай бұрын
Good tip
@vladimirkosiachenko 10 ай бұрын
Hello. What's the scanner model did you use? Thank you.
@airbagsunlimited 10 ай бұрын
We use the Autel MS909
@mayowaodus6310 11 ай бұрын
Excellent video. Do you mind sharing with me the reflector distance on the right and left rear of a lexus Rx350 2015 and also the distance at mid point from the rear. Should my reflector light be pointed towards a dot located on the bsm module
@airbagsunlimited 10 ай бұрын
I would need to hook up to your vehicle and enter the calibration procedure for your vehicle to confirm the distance. Once the correct distance is achieved, I center my corner reflector laser to the center of the blind spot module.
@guyfree0 Жыл бұрын
I just had mine installed today but sadly when driving home, it couldn't detect any cars in my blind spot. It only detected 2 cars out of 25 cars. The cars are faster than my speed and are within 50 feet. What is wrong?
@airbagsunlimited Жыл бұрын
Sorry to hear you had a bad install. It could be a number of issues. Unfortunately, I can't say what it is without looking at it. If you are in the NW Houston, Texas area, we have a brand new 20K square foot shop. I can take a look at it and let you know something. Our new shop is Corporate Collision Centers, 14800 Hempstead Road, Houston, Texas 77040. You are welcome to call the shop at (281) 888-9639 and ask for Brian (the shop owner). Let him know the make/model of the car and talk about the issues. Thanks for stopping by the channel.
@MegaAlex010101 Жыл бұрын
nice job! I have the same vehicle with the same issue. The vehicle was involved in a small fender bender dealers said needs new right headlight and Radar Distance Sensor Mount Bracket plus ADAS Calibration. How much does it cost for the calibration alone?
@airbagsunlimited Жыл бұрын
Sorry for the delay in responding. We just opened our new autobody repair and ADAS facility. Corporate Collision Centers is in NW Houston, 14800 Hempstead Road, Houston, Texas. Gessner and Hempstead Road. Call the shop at (281) 888-9639, ask for the shop owner Brian. He can give you a price for ADAS calibration - we can now do complete autobody repairs.
@MegaAlex010101 Жыл бұрын
@@airbagsunlimited am in VA Beach, Texas is a bid too far for me travel. But after taking the bumper off it looks like the metal bumper behind is slightly bent as well and may need replacement.
@goodvibes1850 Жыл бұрын
U didn't show us shit horrible video
@mfahlers Жыл бұрын
This is not an install video because you did not show us how to install the unit.
@seshagiri6438 Жыл бұрын
Thank you for sharing the information
@moneymanfernando1594 Жыл бұрын
You did not show us the installation process.
@abarca1309 Жыл бұрын
Question how much cost to do ADAS calibration?
@airbagsunlimited Жыл бұрын
Sorry for the late reply. I am uanble to provide you with a cost. We have a brand new autobody repair shop with an ADAS room. You would need to bring your car to the new shop (if you are in the Houston area) for an estimate. Corporate Collision Centers, 14800 Hempstead Road, Houston, Texas 77040. You can also call the shop at (281) 888-9639 and ask for the shop owner Brian. He would be able to tell you more.
@khawaryazdani5503 Жыл бұрын
Awesome video!
@xavieuhr Жыл бұрын
thanks, helped me out bench testing a set of lexus sc400 highbeams before i pulled them out of the junkyard.
@rickjohnson1266 Жыл бұрын
A really good video. This is a crew that did the extras, I see them as the old fashioned type of people who can be trusted to do things well. I wonder where they are located at?
@airbagsunlimited Жыл бұрын
Sorry for the late response. We have a brand new shop in NW Houston. Stop by if you are in the neighborhood and let Brian (the owner) know you saw his videos on KZbin. 14800 Hempstead Road, Houston, Texas 77040 (281) 888-9639 is the office phone.
@alex_will_know Жыл бұрын
Title says 2012 but the tech said it was a 2020.
@paulmondragon4677 Жыл бұрын
Autel system is very nice but will not work for a certified Nissan collision repair center. Only can use oem tools.
@MarioHernandez-bn6pm Жыл бұрын
You do airbag module crash data ?
@airbagsunlimited Жыл бұрын
Sorry for the late response. Yes, we do. We moved into a larger shop in NW Houston. If you're in the area, you're invited to stop by. The new shop's name is Corporate Collision Centers, 14800 Hempstead Road, Houston, Texas 77040 (281) 888-9639 is the office phone number.
@gchesterfield7442 Жыл бұрын
Are you all still in business?
@airbagsunlimited Жыл бұрын
Sorry for the late response. Yes we are still in business. Now we are a full service autobody repair shop. Just moved into a much larger shop in NW Houston. You are welcomed to stop by and check it out. Corporate Collision Centers, 14800 Hempstead Road, Houston, Texas 77040 (281) 888-9639.
@youssefben4863 Жыл бұрын
BSM de mon toyta RV4 2018 est pane
@4jiggaalways Жыл бұрын
Was hoping you could have gone more in detail with installation on rear wiring/sensors.. 🤷♂️
@erl7466 Жыл бұрын
ok vid. wouldn’t have minded you showing the calibration steps on the tablet. it looks like you may have been using an Autel Maxisys?
@divad4711 2 жыл бұрын
What’s the part no?
@Cidredd3 2 жыл бұрын
Video title says 2012… I am confusion
@elmandalorian6671 2 жыл бұрын
Excellent video 📹! Thanks for posting the details of the calibration procedure. Terrible when someone hits your parked car and drives you crazy to try to figure out why suddenly you got a bsm failure mode.
@durvalrebelo2624 2 жыл бұрын
I wanted to see the installation, not alot of explanation on how it works.
@peterbergeris6510 2 жыл бұрын
I was told not to use syn 3. No mention of ingredients on bottle.
@peterbergeris6510 2 жыл бұрын
I hope you didn't just let the bike idle n think it's warmed up. Need to ride it for 15 to 20 minutes. You didn't torque the drain plug. Amzn sells a drainage kit with funnels for the motor, gear box primary, oil filter n oil filter wrench. Don't be cheap. Get the right parts.
@pakmanmoore4255 2 жыл бұрын
where did you order it from
@franknwachi1425 2 жыл бұрын
PLS I NEED YPUR HELP My BSM IS MALFUNCTIONING ON MY 2019 RAV4,PLS CAN I REPLACE IT WITH ONE REMOVED FROM ANOTHER RAV4 PURCHASED FROM EBAY.
@airbagsunlimited Жыл бұрын
Sorry for the late response. We moved into a new shop in NW Houston, Texas - just opened June 1st. Full autobody repair, ADAS and electrical. Corporate Collision Centers, 14800 Hempstead Road, Houston, Texas 77040 (281) 888-9636 is the office phone.
@NinaRossBusiness 2 жыл бұрын
Looks good! Looking forward to watching the transformation 👍
@us-nic6121 2 жыл бұрын
Hello, thanks for the video! Will this system work fine in a 2014 Honda Ridgeline? I wonder due to the license plate location on the truck, that the middle area of the bumper where the license plate is located is "deeper" than the side sections of the bumper. Thank You!
@brandoncadena3025 2 жыл бұрын
Does the recalibration actually work? I just bought a nissan sentra 2018 8 months ago and having this problem with my front radar sensor where it says on the screen "Malfunction" I took it to my dealership and they took the vehicle to a nissan repair facility and said that it needed to be recalibrated but I also been hearing that even if you get it recalibrated that it doesn't work and the same problems comes back
@NoSpillsChills Жыл бұрын
Did you ever get this fixed?
@brandoncadena3025 Жыл бұрын
@@NoSpillsChills yes I did actually they fixed it months ago and it works the sensor never malfunction again it turns out it was a part of the sensor called "The bracket" which was causing causing sensor to show on the dashboard "Malfunction"
@NoSpillsChills Жыл бұрын
@@brandoncadena3025 who fixed it? And how much did you pay? I been looking into it, I can’t find a sensor or bracket.
@brandoncadena3025 Жыл бұрын
@@NoSpillsChills you got to take it to a nissan dealership and tell them to look at the bracket if that's not the problem then it's something else but mine was fixed and I had to pay out of pocket which was $1,200
@vndttaproductions799 2 жыл бұрын
Great video!
@kevinbingham2357 2 жыл бұрын
Hello I have a new 2022Chevrolet Silverado custom what would it cost to install on my vehicle?
@yin-n-aut 2 жыл бұрын
Also got a impact on my sienna on the right side. Will try this out and see. Very Very Helpful!
@mecit03 2 жыл бұрын
Hi there What scantool you use to do this calibration?
@JoshuaCyberNerd Жыл бұрын
I think he said Autel.
@nathanday4964 2 жыл бұрын
just saying it took you 30 mins to do a 3 shot on a nissan it takes me 15 mins to setup do the work and go to the next car also my setup in mobile
@globalcommerce7654 2 жыл бұрын
What equipment do you use?
@iMMO_Slayer Жыл бұрын
Nice. But this man wasn’t in a rush to complete this calibration. This content is geared towards the intention of educating others 🫣💵.
@user-nn3py8iv8v 2 жыл бұрын
Hello! Thank you for the video. I am the owner of a 2017 Sienna, my blind spot sensor requires calibration, is it possible to do this at home?
@erl7466 Жыл бұрын
nope. you need the obd interface, oem or other tool sys and the approved targets. all are expensive as hell. not to mention you have to apply to your pcm which you do NOT want to do without experience and training.
@muhammadyaseen7550 2 жыл бұрын
Sir please you can send me mobile number and whatsapp
@AggiePhil 2 жыл бұрын
Would've been nice for him to have shown some of the adjusting. Did he adjust the sensor bracket position or something in the software? Are you actually calibrating the sensors or just confirming proper sensor positioning? Some more information would be helpful here.
@GeneBrie1 2 жыл бұрын
Hi! what happens if my car is missing the pre collision radar sensor?? I'm currently fixing a car involved in a front collision, and everything seems to be normal except it doesn't move at all, It turns on, the transmission seems to go into gear, but the car doesn't move when I hit the pedal; it is definitely missing the radar, is that why it doesn't move??? or could it be something else?
@nathanday4964 2 жыл бұрын
1 you have to order it 2 its something else
@XellosMetallium 2 жыл бұрын
where your cables connect to?