Backzone Plus Sensor System by Rostra on 2013 Toyota Tundra "Install and Review" Part 4

I recently installed this Backzone Plus Sensor System by Rostra on a 2013 Toyota Tundra and did a product review that talks about the system and ease of install. In this fourth part I will show how I ran the cable/wire to the module in the tail light. My Team and I install this backup sensor system on your truck, fleet vehicles and automobiles. Contact me now and schedule your appointment: [e-mail]
Let me know you stopped by: SUBSCRIBE - WATCH - LIKE - COMMENT - SHARE
Thank You for supporting the channel.
DISCLAIMER: THIS VIDEO IS NOT A PRODUCT ENDORSEMENT

[@NinaRossBusiness]

Great that you do the pre and post scans for your customers. Like the detail in the video. Thanks for posting

[@ForeignMRE]

Good info. Question: any recommendations for getting those plastic angled clips out without breaking em?

[@airbagsunlimited]

Good question. Gently remove the sill panel, which is the trim piece running parallel to the seat, then gently pull the kick panel toward the center of the vehicle from the bottom. The retainer clips usually pop out with the trim panel, but, if they do not, then you can use a panel popping tool.

[@TheFLguy75]

Your video series here is stellar....When you say "go through the floorboard" did you use an opening already there or did you make a hole? I have the same Tundra and I want to install this product....