Glad it helped you. I was just happened to take the video after helping out a local couple by replacing it for them.

www.3m.com/3M/en_US/vhb-tapes-us/ would be the best place you can look that I can find. Yes they make slightly different kinds but the basics are all the same and it's mainly width of thickness that differs. But it's the same stuff that the OEM's use to put it on in the first place so no reason to try and reinvent the wheel since it is mainly there to prevent rattles and give a little extra hold power.

@@VentShop Thanks

@@VentShop Hi thanks for the video, do you happen to remember what width the VHB tape was amazon has all different sizes and I wanted to buy the tape before I pull it apart. Thanks

@@StuMagoo around 1/4 to 3/8 inch wide will work. There is a little extra room where it is placed.

@@VentShop thank you so much

No problem, glad it has been of some use. Hate spending tons of money at the stealerships myself so figured may as well spread the info to others.

There is a double sided adhesive foam strip that helps to seal it all down. You will have to pry up on it pretty hard to get it to break free or have a thin flexible blade to slide in between. You can see in the video where there is a strip that is partially removed about 6 seconds in. You will want to pick some up as well when you put it back together, it's often called VHT tape.

I literally bought it brand new from newegg. I would have sent it back to them for a full refund.

I contacted them and eventually they sent a replacement block. If the top of the block where the ports are is not perfectly smooth it is defective. The o ring can not seal any bumps or ridges. They sent out a block from one of their better systems I believe the evo and it has been working fine so far.