That first transmission that you said is not serviceable is 100% serviceable. You trick people into thinking you that they need to bring it to you for repair or to sell them a used or new one. Shameful.
@markbriggs2443Ай бұрын
I could not hear what you were saying about the hydraulics up front
@johndenver85742 ай бұрын
The X3 series is the most common tractor john deere sells. More homeowners buy this model then any other.
@craigtappy24413 ай бұрын
Looking for the electrical harness off the LT155.
@chrisjimerson87903 ай бұрын
so you can leave the Mator running when its in park
@boonslickequipment36103 ай бұрын
Yes, with most riding mowers, you can leave the motor running even when you're not in the seat so long as the parking brake is set.
@chrisjimerson87903 ай бұрын
@@boonslickequipment3610 oh ok cool is that with every 100 series 200 series mowers
@icemikebullcity083 ай бұрын
Do they sale a bagger for this tractor? I can’t find one
@n0ukf3 ай бұрын
Our Cub Cadet has a different stiffness problem. As far as I can tell so far, the forward/reverse shaft going into the hydro transmission is where the stiffness is, not the pedals or linkages.
@RhinoXpress4 ай бұрын
You can xthange the oil on the first one. There is a black seal cap at the top that you pop off and you can drain it by flipping it over.
@harveydoyle79704 ай бұрын
How much is it?
@boonslickequipment36104 ай бұрын
This garden tractor is listed for sale for 2500
@boonslickequipment36104 ай бұрын
Here is additional information: boonslickequipment.com/?p=1608
@ourv96034 ай бұрын
How to tell a Garden Tractor from a Lawn Tractor>>> Look the the rear hubs, if you see lug nuts, its a Garden Tractor. !
@BenjaminBarton-ei6jh4 ай бұрын
Is this tractor still in stock and available for parts purchase? Thank you.
@patrickh.54355 ай бұрын
Just fought this, not cured yet but same symtoms replaced ignition coil and still doing carb should be here tomorrow and hopefully that leads me in the right direction
@FixNewsPlease5 ай бұрын
Needs valve seals. Common in the 17hp Kawi
@mikenj25 ай бұрын
Man that RPM sounds too high
@landen_5765 ай бұрын
Hey there i got one with a 16hp vanguard with a little over 200hrs it seems to get hot then shut off then after about 20-30 mins later it’ll run fine for a little bit then it’ll shut back off like its over heating it sat for many years most of its life in our basement it had a really bad surging problem but i got it to idle crisp but it seems to not wanna run any tips?
@boonslickequipment36105 ай бұрын
Gosh, its hard to say without looking at it, it could be an electric component getting hot, or any other number of issues. Best of luck!
@charlesdeutsch35435 ай бұрын
Had the same problem, very frustrating! Glad I found your video! Replaced the time delay module and that fixed my problem. Thank you for your video!!
@Rob-Heaston6 ай бұрын
Thank you so much! I hope this is what I'm dealing with. I can cover the intake and it fires right up. I think this is the problem
@RodneyRose-d8q6 ай бұрын
How much horsepower is it?
@Magsonln6 ай бұрын
i have prob w X534. After running 20 to 30 minutes, it starts to cut off and then it finally stops . I replaced the ECU but it only takes 20 to 30 minutes of mowing to do the same cutting off until it won't start. This means I have to mow my three acres in 20 minute periods on one day, wait overnight and do the next day and again until my mowing is done. Had it serviced by JD and they said nothing wrong. What's the fix?
@boonslickequipment36106 ай бұрын
With the X500 series, we have had problems with the time delay module. That would be the likely culprit. We made a video on that specifically, I've copied the link to it below. Another thing it could be is a plugged fuel cap vent. Other than that, this video might be helpful for you, we go over a few problems that it could be: kzbin.info/www/bejne/oJrNlKGFhbGBm5o
@boonslickequipment36106 ай бұрын
kzbin.info/www/bejne/oJrNlKGFhbGBm5o
@jb1219936 ай бұрын
Mines at a supper high throttle that won't adjust, regardless of what I do with the lever. Am gonna do the opposite of what you instructed to see if that fixes the problem.
@s2safety6 ай бұрын
❤❤
@BSS221936 ай бұрын
This tractor looks exactly like a Snapper LT100, only the decal on the hood is different, some of the adjustments on the deck and the handle for the throttle. It seems to be in good shape!
@Lavackfarmboys6 ай бұрын
It also looks like a simplicity mower must all rebadges
@boonslickequipment36106 ай бұрын
Simplicity Manufacturing brands include Simplicity, Massey Ferguson, AGCO, Deutz, Snapper, and others. It very well could be the same machine with different branding.
@allanstriber52726 ай бұрын
So that's impressive it goes backwards and in a circle
@boonslickequipment36106 ай бұрын
Isn't that neat! Deere sure knows how to make 'em!
@RickyPatterson-c5e6 ай бұрын
Where r u at
@boonslickequipment36106 ай бұрын
We're located in central Missouri
@RickyPatterson-c5e6 ай бұрын
@@boonslickequipment3610 ok
@bobhunter30506 ай бұрын
Ya know , the price tag pay for these , wouldn’t think they wouldn’t be made out of PLASTIC !!! The hood and grill .
@boonslickequipment36106 ай бұрын
We see the grilles and little green "bumper" underneath the grille broken often. The hood on these X700 series machines, though, seem to hold up pretty good even though they're made out of plastic. It seems like John Deere as switched to plastic on most of their lawn and garden equipment and even some of their tractors, too.
@krowbar236 ай бұрын
500. Bucks but tail lights not working mite give 600. If you can deliver.😅😅😅
@boonslickequipment36106 ай бұрын
The X530 does not have tail lights. What you see on the back are reflectors only.
@roberthicks66776 ай бұрын
Where are you located ?
@boonslickequipment36106 ай бұрын
We're located in central Missouri
@shawnlay25756 ай бұрын
How much do ya want for it
@boonslickequipment36106 ай бұрын
This Massey Ferguson is priced at $1250
@claudepatry97986 ай бұрын
I do have exactly the same tractor and love it. Like this one I have mutch more hours on the meter than it really had. It happened because at fist by accident, I stop the engine stepping off the seat at few occasions. The meter continued adding hours til the battery went dead. I think same ting happened to this one. It is the best machine I ever seen co.pare to many other brand.
@harveydoyle79706 ай бұрын
How much? $
@boonslickequipment36106 ай бұрын
This X530 is priced at $3950
@Dre.Day86536 ай бұрын
Ha I need a mower deck for a S2554 🤕🤔💬
@chrisrhoads82567 ай бұрын
I got one last month its used 700 hours with not a hole lot / as theses days/ 🚜💪🤛👊🤜👍🥊🤘
@ryanmiller69007 ай бұрын
On average how many hours or how long should a John Deere 300 series or the newer GX series last
@boonslickequipment36107 ай бұрын
Longevity in terms of hours on any machine depends on proper maintenance, willingness to repair, and good ol fashioned luck. That said, we regularly see 325, 335, 345, and GX series machines in our shop with well over 1,000 hours. The most I've seen on one was an early 90's 325 with over 2,200 hours.
@3339dennis7 ай бұрын
Thank you, saving me 175.00 hrs at john deere
@freedomforever67187 ай бұрын
Very good tips.
@nancylandes34617 ай бұрын
That is exactly what ours has done for years and the Wichita KS dealer could never diagnose the problem . Thanks for the great video. Scott
@fairlanefivehundred8 ай бұрын
My X500 gave me fits with this issue. I read somewhere on a forum to look near the starter on the engine right side, for a single black wire, and just unplug it. I did this 2 years ago. No more stalling. Starts every time! Didn’t buy the overpriced $100.00 gizmo, either
@fs22gamer-pr4xt8 ай бұрын
My neighbor has an x300 and does the same thing
@Highlanddragon8 ай бұрын
Looks just like mine
@MI_Duneclips8 ай бұрын
I have a lx288 and installed a new battery and still getting no power to the dash. No crank unless i throw my jump pack on it. Shuts down right after its taken off
@Richard-gi9cj8 ай бұрын
Q x540 when cold I try to engage the blades and the engine stalls. When I’m cutting the grass and it gets warm. Engine starts to spit and sputter and will stall. Help
@peezyplayz24988 ай бұрын
my buddy has an onan with no cooling fins from the mouse piss corroding them off.
@treerobo68648 ай бұрын
I have one just like it ,it had been a good mower I have 375 hours on it and have not had any problems yet,the seats are a little cheap mine had tore where it was sewn together
@transistorradiorecords36618 ай бұрын
I have had the same exact problem with my JD s240. Going to look into this tomorrow. I have 3 1/2 acres to mow and it gets frustrating only being able to mow an hour at a time. When it cools off, it starts back up. Is this module fairly standard on all JD mowers?
@georgestrickland92788 ай бұрын
usual john deere,no hood because of the cheap plastic they use, i have a collection of them and have spent a few thousand on replacement goods
@elijahbey33668 ай бұрын
WTF happened to that thing? It looks like it was hit by a heat-seeking missile.
@RalphBeach-ns3yy9 ай бұрын
I know you sold the mower already...my question is, what specific motor does this mower come with? We bought this exact mower and it had an 18.5 motor...
@2004DodgeRam9 ай бұрын
Before i do this would it still be the case for the cylinder to sometimes fire and also have a wet spark plug when it gets taken out?? It’s getting fuel just not sure if it’s enough if that makes sense
@ericsloan6168 ай бұрын
I have the Kawasaki 641v 21hp and it's doing the same thing.. has fire and the right cylinder will every now and then start running as it should. Had to clean the right side of the carb. Sometimes we just get a little trash in are gasoline
@kregalis8 ай бұрын
Will this also make it vibrate Alot when running
@christianperoni69889 ай бұрын
Tondeuse john deere 355d
@christianperoni69889 ай бұрын
Recharge pare choc avant tondeuse john deere 355d
@christianperoni69889 ай бұрын
Pare-choc avant tracteur tondeuse Jhon deere 355d
@MaxvanBrian9 ай бұрын
Thank you! I have this exact model. I’m trying to find the proper bagger system with no avail. Would you guys know?