I dropped my credit card right in between the cupholder and the shifter. Without this video I'd be fucked
@taicollins23035 ай бұрын
BRO YOU HAVE NO IDEA HOW MUCH YOU JSUT SAVED MEEEEEE
@Timeforachange1 Жыл бұрын
I will subscribe to your channel sir, but you're using profanity at the end with these songs.
@ronnierodriguez37392 жыл бұрын
Bummy af
@nflores54333 жыл бұрын
Just bought some adhesive carbon for mine.. roll for like 10 bucks online. DIY vids on KZbin. Haha
@beardsbucks23654 жыл бұрын
Where is the bulb at mine is out need help to replace it
@NocThunder Жыл бұрын
When you remove the plate that has PRND printed on it, the bulb will be on the left side. To remove the plate you will need a flat head screwdriver to lift the tabs and move the plate to the side.
@TristanJCumpole4 жыл бұрын
You didn't use a primer on the raw plastic. Ideally you'd need to spray a grey primer, sand that smooth and re-apply a couple of times. Then apply a good quality colour coat, preferably followed by a strong protective clear or a mix of colour and lacquer if budget is a concern. This paint will look terrible and cheap very quickly once you get adhesion issues and a bit of wear. Hope this helps when you need to re-do the paint!
@GARYTF23 жыл бұрын
Wassup! You think I could try your process? I’m down to fix up my cup holder , it’s just scratched up from previous owner. If you could help me out with a shopping list that would be great. This is on my 2007 Charger
@lajuanofficial37305 жыл бұрын
I got a 07 Chrysler just got some dubs I haven't put em on yet. Yo whip clean as hell bruh 💯
@pcking20086 жыл бұрын
Nice job man. Angel from the Bay
@mikesquad30036 жыл бұрын
Clean af
@mrvantaztic6 жыл бұрын
150 grit?
@TristanJCumpole4 жыл бұрын
Yeah, way too coarse. The soft-touch paint comes off with a little alcohol anyway. I found this out mid-pandemic when I got hand sanitiser on the console.... At worst, the surface should be taken through the grits to about 240 if there is major surface scratching, however I'd be more likely to give it a skim of poly filler and start straight at 240. A high build primer might cover 150-180 but needs flatting at 240 before colour coats anyway. Came across this video because I'm vinyl-wrapping the centre console with 3M brushed black metal after a custom Android install. Just needed to know how to remove some parts and see how other people got along.
@larryburnham50936 жыл бұрын
Did you need spacers ? And ehat size tire
@fulmpictures67727 жыл бұрын
hello, may i ask how you reached the two bolts and got under the tray?
@NocThunder Жыл бұрын
The tray can be popped off with a flat head screwdriver. It comes off very easily. Once it is off, you will see the two screws so make sure you have a Philips head screwdriver.