#043

[@Indeewoods]

Seems like it could use a smaller sprocket to get those rpms up a bit

[@theleafsprungjeeper]

I have a question. On my Pioneer 1200A, the throttle linkage is fine but the part on the carburetor won't move more than a millimeter. I disconnected the linkage going up to the carburetor and tried to move it with my fingers without success. I have never actually fired up this chainsaw. It was a gift and I just wanted to clean it up and that's when I noticed the issue. Any advice would be greatly appreciated. Thanks.

[@craigprucha7372]

Hi @theleafsprungjeeper, Sorry I haven't gotten back to you sooner. What I would suggest about your carb shaft being stuck, is to pull the carb off the saw and soak it in some heavy duty cleaner for a few days. this will hopefully dislodge any build and will free the shaft up. There a pretty simple carb if you need to take it apart and carb rebuild kits are available for these carbs. Take care and thanks for watching the video...

[@theleafsprungjeeper]

@craigprucha7372 Thank you. Others also suggested the same and it worked!!!