08 BUICK ENCLAVE REAR UPPER CONTROL ARMS REPLACEMENT PART 1

[@douglasanderson1151]

Much appreciated, just did my entire front end suspension and cv axels and was not sure on the back. You cleared it up for me!! Also, liked the music choice ;) !

[@rhurtadorh32]

So in what direction you install them bolts the ones that are adjustable? Or do i have to take it to get wheel align?

[@vetmech4554]

I tried to get them in the same position until I could get it aligned. An alignment is a must after this job.

[@randybadgero4945]

around the 10:00 minute mark were you able to twist off the washer? Bolt on mine turns, but not freely.

[@vetmech4554]

Randy Badgero I was able to remove one side without any issues, but the other side I had to use a flat tip screw driver and pry it loose. If your able to turn the bolt from the other side it should loosen it out of it’s notches. Hope that helps.

[@billycocky]

Did ur truck feel like it was wobbling from right to left on the highway ? I got the same problem and was thinking it’s the Lower a frame arm .

[@vetmech4554]

billy cocky, yes sir it did. It’s most likely your ball joints or inner rubber bushings. To be honest it is cheaper to buy the entire lower control arm because it comes with all new bushings and ball joint. That’s what I did and it saves you from pressing out the ball joint. Hope that helps. Thanks for watching!

[@perfectbeauty7220]

😍😍😍😍😍👍🏻