Doesnt he have to subtract 3/4 (the armaflex thickness) from the 9 5/8 and then start from there
@pexx994 ай бұрын
That is wrong. If you do that the outer side will be too long and you need to trim both sides. You cannot just flatten half pipes and do 90 degrees. It is less than that.
@bsbs82267 жыл бұрын
very nice
@nailsongomestenoriotenorio70227 жыл бұрын
barani pandian oi
@pasasalink7 жыл бұрын
Good lessons for childrens, and I think this teacher need more practice, because he learning others not correctly. NOOB
@sedatgelenoglu91862 жыл бұрын
ArkadŞiar Türkçe çeviri lütfen
@JRPchef8 жыл бұрын
Armaflex is not suitable for steel pipe, I guarantee you are going to take ten years of of that steel pipes life. Armaflex is for copper.
@Badger322846 жыл бұрын
jrpNH3 the US Navy uses armaflex on all piping and components that dont get hot on their boats.....