13. ASA 5505 in Packet Tracer CLI configuration

CCNA Security
Chap 4. ASA Firewalls - real world labs

[@sidogr9854]

Fantastic !

[@NamacilHDx]

i from the future, 2021. its still the base license :(

[@medkaderabdillahi6154]

that good brothers ,good job

[@glen2003]

question, isn't the reply back from the router's loopback to the inside network shouldn't work? since the default behavior of the asa is from lower security level going to high security level is denied by default? inside network security level is 100 while outside has 0

[@jean-lucpicard5510]

Nov 2021 I don not think failover has been added yet?

[@emilienlefort9707]

Hello, I follow the instruction but it's not possible to ping from inside to outside ... The icmp do PC0 =>ASA (NAT) => R0 => ASA and then the error message : The ASA does not allow any traffic from a lower security interface to a higher security interface unless it is explicitly permitted by an extended access list. Can you explain why ?

[@leeonthego]

can you do more ASA firewall please

[@arpanvora3103]

what is the default password of enable

[@NamacilHDx]

nothing just press enter

[@jaysonlee1082]

No matter how i just cant get assigned with an IP address as yours is 1.1.1.2 but i cant get anything(unassigned)

[@geraldirvin2423]

same here. did you figure it out?

[@gustavomendez6279]

Gerald Irvin it’s dynamically assigned so it’ll be randomly pulled from the ISP router as long as dhcp is configured correctly on the router (at least that’s what I gathered from this)

[@geraldirvin2423]

@@gustavomendez6279 It finally worked. I think I missed a step.

[@davidappiah532]

Well I got exactly the same IP address

[@keppensfx]

i cant ping