18in cabinet with pull out Recycle/Garbage can.

Created by InShot:inshotapp.com/...

[@scottstatham8019]

Nice job. Your video filled a couple of voids in my planning.

[@lanirr4]

I really like this build. About how much did you add to the width of the cabinet in comparison to the width of the trash cans?

[@joshgandy148]

The face frame opening is 15 3/8. The garbage can top is 14 3/4. Leaves you with 5/8 ÷2 gives you 5/16 on bothsides. Hope this helps you .

[@elliesampson5893]

Step by step is stating sizes and cuts!!!

[@DPproductionsHD]

This is exactly what I need to create for my kitchen. I don't have extra cabinet space to place pull out trash cans in an existing cabinet so I'll to do a free standing cabinet like this one. My shop and woodworking skills are quite a bit below yours though. Do you have advice or recommendations for slightly simpler version of this? Thanks for sharing your work.

[@joshgandy148]

If your looking to do an easy version i know they sell pull out kits that have the slides brackets and cans on amazon. Rev-A-Shelf 53WC-1835SCDM-217 Double 35- Quart. All you would have to build is your cabinet box and door the kit would cover the rest. Let me know if that helps.

[@DeadBeatsPro]

I really would like to see the island attached to it

[@joshgandy148]

If you watch my last video it will show the kitchen done the pull out garbage can is at the end of the island. kzbin.info/www/bejne/hHKYfqiNnahpjNU

[@KaskadeHD]

what kind of wood is that

[@joshgandy148]

The plywood is 3/4 maple veneer. The hardwood is also maple planed down to 1/2 inch.

[@mrtrader4628]

Nice I like it ... about how tall was the drawer box 6" to 8" ?

[@joshgandy148]

The outside of the box is 8in. Inside the box is 6in.

[@stevehinton5300]

What pocket drill jig would you suggest. .?

[@joshgandy148]

I use the kreg K5 master would definitely recommend.

[@BIGFISH0759]

why did you use pocket screws vs tenon and mortise joints?

[@joshgandy148]

I use pocket screws when working with plywood. Normally use mortise and tenon joint with soild woods.

[@zmdrummerboy]

Where did you find the cans? Looking for a set like these.

[@joshgandy148]

They are from rev a shelf . I ordered them from amazon

[@chadlarson6261]

Do you have a link for the hardware (soft-close rails)?

[@joshgandy148]

I do not have a link for the ones I ordered they were off Amazon blum 563H and then the length you want. Hope this helps.

[@S0L1D_]

what's the size of the garbage can?

[@joshgandy148]

The cabinet is 18in wide 34.5 tall. 21in deep. The garbage can is from Rev-A-Shelf LxWxH 10.75 x 14.75 x 21.75 inches.