Thanks for sharing your video I have a 99 Tahoe as well I love the way you accessed the pump you just saved me a lot of time
@spelunkerd2 жыл бұрын
Interesting story, creative approach to the pump. I find the excess fuel in exhaust confusing, but it is hard to argue with results.
@RustBeltAuto2 жыл бұрын
Yes. Unburned fuel from too much air. The air from the starved flame prolongs the burn, and fires the next intake stroke, causing a backfire. In a normal combustion process the flame front puts out the fire, by using all the air. A rich condition runs out of air, and overly lean has too much air, and not enough fuel. What comes out the tailpipe looks, and smells the same. With that distributor, and pump, thus truck never ran this smooth for me.
@derekkeith1082 жыл бұрын
Crimes pays but botany doesn't is one of the greatest youtube channels.
@RustBeltAuto2 жыл бұрын
Agreed
@bkp83452 жыл бұрын
Thanks for the thorough explanation of the flame front. Shit always baffled me but your wording was spot on!
@howdy4596Ай бұрын
Love living in Arizona . Both my 2 door tahoes have no rust at all.
@dirtwolfmtb6 күн бұрын
Im about ready to cut a hole through the floor like you did lol. I miss my subaru
@waseemkhan-ms1kt2 жыл бұрын
This is a very smart way to do the fuel pump. Like.
@Rider-nb5ts10 ай бұрын
This is fantastic! If I wanted to seal the seam so nice ductwork aluminum tape is cheap!
@ruthlessone3k Жыл бұрын
LoL, I came here hoping you did it like this. I really just needed to know where to cut the hole in the floor
@elementalmetal1745 Жыл бұрын
Hi. What did you use to cut the access hole? I've had my 99 Tahoe for many years. It's on the 3rd pump. It went out last night. With a full tank of course. I'm considering this even though it has no rust. But it is sitting out in the snow and rain. Thanks a ton!
@RustBeltAuto Жыл бұрын
High speed metal air saw.
@elementalmetal1745 Жыл бұрын
@@RustBeltAuto Awesome thanks. I'm going to try a nibbler to keep the mess down.
@Chris_at_Home Жыл бұрын
I have a 98 K2500HD and the fuel pump quit when I went to move it to plow snow in December. I cut a hole in the bed similar to this with a thin cutting wheel in a grinder to change it last week. It was so nice to hit the key and it started right up.
@deemoney71502 жыл бұрын
Helped me a ton! Thank you
@RustBeltAuto2 жыл бұрын
😁
@billlawson7511 Жыл бұрын
Great video
@aaroningle92962 жыл бұрын
So I'm going to cut a hole in the floorboard as well but what is the easiest way to make sure I line it up correctly?
@RustBeltAuto2 жыл бұрын
Make a small hole, and look in it. Good luck.
@dam_bravo6142 жыл бұрын
Really helped me out thank you
@kamnichand79905 ай бұрын
Very nice
@gilly5087 Жыл бұрын
Great info here
@freshbutplain1144Ай бұрын
Do you have to replace the connector with the one provided or can you just use the factory plug?
@RustBeltAutoАй бұрын
@@freshbutplain1144 the original connectors can wear from heat. Like a toaster.
@freshbutplain1144Ай бұрын
@@RustBeltAuto ah okay if it seems okay I’m fine with reusing it? Thank you 🙏
@alexraccuia75502 жыл бұрын
Thanks for the vid!!
@jessehendrix8707 Жыл бұрын
I'm trying to understand what the center connection is used for between the fuel lines.
@RustBeltAuto Жыл бұрын
EVAP?
@shawangunk2 жыл бұрын
Good job ! Did that before.
@alexthemechanic81102 жыл бұрын
Good work man. Lots a good information !! And i love your bodywork hahahahahaha
@alexraccuia75502 жыл бұрын
Thanks got the vid!!
@calebturner12307 ай бұрын
What is the red tool you used to remove the hose
@RustBeltAuto7 ай бұрын
You mean one of these? www.ebay.com/itm/355115515439?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=lkyveuoqtpe&sssrc=4429486&ssuid=QXZTigxVTHS&var=&widget_ver=artemis&media=COPY
@JoseDeLosSantos-pm8sn7 ай бұрын
I have a 99 Tahoe gas gage doesn’t work any suggestions
@RustBeltAuto7 ай бұрын
As a guess, normally if it is pegged over full there is an open circuit (broken wire/bad connection). Under E, or stuck in the same spot is a sender in the tank. If it is erratic, and doing senseless things like it is posessed, there is probably a gauge issue.
@-The-Mon2 жыл бұрын
when you were removing the rust from the tabs , fragments were dropping in to the fuel tank, this is not good
@RustBeltAuto2 жыл бұрын
Brilliant observation.
@uknowwhothehelliare78212 жыл бұрын
@@RustBeltAuto lovin it 😅😂😂😂
@fordwindsor3512 жыл бұрын
If this work was known to be done and in some states that are very strict or picky with the annual inspections this cutting your floor to do that job would equal a fail, unless the proper mending of the cut piece of floor was done right.
@RustBeltAuto2 жыл бұрын
How would they know? If it was a victim, I would probably do it differently too.
@fordwindsor3512 жыл бұрын
@@RustBeltAuto yeah I guess it would be hard to know it was done that way but if for whatever reason they found the floor was cut open and not properly sealed, that's clearly a safety violation.
@RustBeltAuto2 жыл бұрын
@@fordwindsor351 i worked on a lincoln once. Took over 2 hours to drop the tank to find a hole cut under the seat. The dealer did it years before under warranty.
@fordwindsor3512 жыл бұрын
@@RustBeltAuto Very interesting lol
@BabeKirshh4 ай бұрын
What’s that tool called?
@RustBeltAuto4 ай бұрын
What tool?
@ZacLara-eq2sx10 ай бұрын
👍💯👍
@hankgs2 жыл бұрын
Were you in that Movie "FARGO".....???
@RustBeltAuto2 жыл бұрын
Just the reality of it.
@troytheboy202 Жыл бұрын
How much did you pay for the fuel pump
@RustBeltAuto Жыл бұрын
I can't remember
@CarlosRomero-bn1bn Жыл бұрын
my point of watching the video,was the wiring. the color codes are off on the new set. you should have explained that😑
@RustBeltAuto Жыл бұрын
Some of those connectors I have done had 2 wires that were in the wrong spot on the pump module.
@CarlosRomero-bn1bn Жыл бұрын
@@RustBeltAuto Sorry bout that, I was being lazy and did do what I learned over the years. It was plain as day using my experience and power probe. Thanx for the vid my fellow tech💯
@Fony_turgeson Жыл бұрын
I thought acdelco pump was the best
@RustBeltAuto Жыл бұрын
Delco is nice.
@beekeeper8474 Жыл бұрын
Why
@RustBeltAuto Жыл бұрын
Because why not.
@kreggkittredge2532 жыл бұрын
Yo
@johnv65422 жыл бұрын
Dougamahikki lol
@HeSavesMankind2 жыл бұрын
Dude what are you doing? SPARKS!!! You're hitting metal together next to a giant pile of gasoline!!!!
@RustBeltAuto2 жыл бұрын
Be brave. Do something.
@Fony_turgeson Жыл бұрын
Pile of gasoline? It's a pile? Ues your the smart one