I spent half of a Saturday driving around trying to find the correct master cylinder for this car. I found out that it had a different thread size and was a mid year change. #fail
Пікірлер: 15
@rescuedandrestoredgarage Жыл бұрын
That is brutal. So much time for such a small job. But you got it done. Save a lot of money doing the job.
@NathansMoparGarage Жыл бұрын
It was definitely a tight spot.
@rescuedandrestoredgarage Жыл бұрын
@@NathansMoparGarage it looked like it.
@TwoDoorTay5 ай бұрын
What’s the part number I have the issue with the smaller port hole
@NathansMoparGarage5 ай бұрын
@@TwoDoorTayDon't have the part number. I remember there were 3 different ones. Advance was the only place that had the one I needed.
@moparnut6286 Жыл бұрын
Yeah a lot like what they Put in the trucks but you have way more access to it in the trucks. The bleeder kits going away sucks that why I keep a box of fittings and lines so I can bench bleed them or do them on the car with the pedal helps keep the mess down, good thing to have working brakes.
@NathansMoparGarage Жыл бұрын
It definitely helps when the brakes work. Had to rinse everything down with water to get rid of all the brake fluid.
@miguelangelcazales31202 ай бұрын
how am i able to tell it needs a new master cylinder? when i brake it goes down to the floor, but no leaking anywhere? could it need a new one?
@NathansMoparGarage2 ай бұрын
If everything else looks good then it could be a bad seal in the master. If you are working on a similar car make sure you get the correct one. There were 3 different options when I did this one and it was a pain to find the correct one.
@VinoRatRodbuilds Жыл бұрын
Yeah I cal that car wars.
@NathansMoparGarage Жыл бұрын
It was definitely squeezed in there.
@UnfinishedProjectDartSport Жыл бұрын
🦕 Brak E osaurus!!
@NathansMoparGarage Жыл бұрын
😂 🚦🦖
@AryDontSurf Жыл бұрын
Pain in the ane
@NathansMoparGarage Жыл бұрын
Definitely a pain, they really squeezed it in there.