Sounds like ficm. With these truck you have to have some kind of scanner to see what’s going on. I use a scan gauge 2. I can tell immediately when something changes. Great truck when it runs right.
@michaelvolin97497 ай бұрын
Buddy, it turned out to be 4 fuel injectors were bad.
@dpdiver14 ай бұрын
You definitely want more fuel pressure than that, it needs to be checked under full load not at idle.. upgrade to the Blue spring fuel pressure regulator kit.
@michaelvolin97494 ай бұрын
It turned out to be fuel injectors.
@dpdiver14 ай бұрын
@@michaelvolin9749 Got it, I've got two E350 vans with 6.0l had injectors installed 2021 2 just went out and shouldn't have didn't do the Blue spring back then but got it done this time. Low fuel pressure will kill injectors. Injectors are less expensive to do in the trucks but in the Vans very expensive because of Labor, really tight access. Glad you got it figure it out but you may still want to add the Blue spring it's only 80 bucks or so.
@qxr20 Жыл бұрын
can pnly know pressure under a load
@michaelvolin9749 Жыл бұрын
I'm not sure of your question.
@lilskibo1 Жыл бұрын
FICM!!!
@michaelvolin9749 Жыл бұрын
I measured the ficm voltage it was correct at 48 volts. Problem was bad fuel injectors.
@stevensdaniel71072 жыл бұрын
icp?? what was the problem??? i have same problem
@michaelvolin97492 жыл бұрын
Steven, the problem was a couple of bad injectors.
@stevensdaniel71072 жыл бұрын
@@michaelvolin9749 Thanxxxx
@michaelvolin9749 Жыл бұрын
It's was a few fuel injectors were bad. Went ahead and changed them all.
@michaelvolin9749 Жыл бұрын
Steven's, please call me I'll explain what I went through. Mike. 570 441 0944
@haydenarmentrout1033 Жыл бұрын
Hey this sounds just like mine does. Any advice after this video?
@michaelvolin9749 Жыл бұрын
It's was some of the injectors, decided to change them all. Truck runs great.
@lukemorrell287010 ай бұрын
High pressure oil leak
@michaelvolin974910 ай бұрын
No, it was just what I showed in the video the string was shorted causing the 5 volts to drop to 1 volt. Unplugged the map sensor and the short was gone. Replaced the map sensor and has been working good.