2006 Ford Mustang radio install visual using metra 70-5521 harness to keep Shaker 500 amps & subs

[@sebastianquintana1059]

I need help, my subwoofers don't work, I don't know how to connect them because they don't have RCA outputs.

[@JoshuaSmith-sb6wk]

Ok so I bought a mustang that has the shaker 500 but the radio was missing. I purchased one of a gentleman for 50$ but is was the base radio without the amp output. There is no spot for the small plug for the amps but the other 2 larger ones are hooked up. I bought the 12v to 5 v converter so the subs won't pop being connected to 12v. The red /black is - and the brown and orange is + for the amps but what would I connect the other 2 wires to? The green and purple and the ones that is a larger wire with the loose insulation on it?

[@fredf4562]

Why didn’t you plug the other connector in?

[@rad_vids]

I only had the Shaker 500 system originally so the factory amp connector only has wires that go to the front door subwoofer amplifiers that are located in the driver side kick panel. The white plug was used to connect to those since those wires correspond to the ones in the factory amp connector. The red plug is not really used if you have a Shaker 500 system since the factory plug does not have any wires that go to the rear amplifiers in the trunk since you won't have them. If you had a Shaker 1000 system with amps and subs in the trunk, then you would use both plugs.

[@fredf4562]

I wrote on your other video the troubles I’ve been having with the Chinese company. So difficult to get info how the get my amp working!!

[@fredf4562]

Thanks for the input, great info

[@darintankersley1774]

On the amp plug you have 1 blue/white going to Yellow wire…where is that wire going?

[@fredf4562]

I bought a head unit from China. I don’t have the output channel. I’m in contact with them to figure it out.