Killer man! Did you open up the engine to gap the rings?
@schamsy32Ай бұрын
@@brandonhayes8757 It's a complete stock 6.1, never opened it up.
@Stage6MotorsportsLLC2 ай бұрын
Congratulations Nick, it was getting lonely being the only stock engine SRT8 Jeep in the 9s. Now how much more do we push these stock engines?
@schamsy322 ай бұрын
I think this is the end of the road for me. Just going to enjoy driving it to work now.
@Stage6MotorsportsLLC2 ай бұрын
@@schamsy32 that’s all I’ve been doing for the last two and half years
@zackarimartel29802 ай бұрын
Hey man awesome jeep. I have a stage 6 built 2007 76mm. What Rpm do you have on the 2 step and how you keep it from not pushing through. Also how much power on that stock motor. Super impressive
@schamsy322 ай бұрын
2 step is at 27-2800... Just have to apply a lot of brake pressure. Never been on the dyno with this setup
@SrtHemiPower3 ай бұрын
What size turbo? Sounds mean
@schamsy323 ай бұрын
@@SrtHemiPower 76mm
@SrtHemiPower3 ай бұрын
@@schamsy32wow that’s insane seen a lot of built motor jeeps with bigger turbos struggle to run 9s 😂
@normanmakaio2 ай бұрын
Man idk how you're cutting 60' like that on just foot brake? no trans brake right? I cannot seem to get my Turbo jeep to do better than a 1.7 Im on a 2 step @2900 full built paramount trans, forged motor and on welds & m&h tires..my last jeep was cutting 1.5's 60' on stock block small cam, headers & a vortech blower.. I needed some advice on lowering my damn 60' 🤦♂️
@schamsy32Ай бұрын
@@normanmakaio foot brake only with stock converter. I would look at the tune/timing in that region of the map.
@normanmakaioАй бұрын
Mahalo for the tip! 🤙🏽 so you must have a tad more Timing set off the get go than I do..I'm not on E85 like you thought..just C16 , but thank you for shining some hope my direction..Mahalo 🤙🏽@schamsy32
@someporkchop56514 ай бұрын
W pull
@MiddNite-yw7fr4 ай бұрын
This thing is a monster 🔥 i think i may have found out what i wanna do with my jeep. You on IG?