2006 Yamaha Grizzly 660 Front and Rear Brakes

[@thomasphillips1832]

Great Video. I watched it and changed my brakes front and back on my 06 yamaha grizzly. Thanks

[@ProTechEpoxyFloors]

Thanks, just did mine today after watching your video. Compressing piston was a big help.

[@MavicAir1]

Thanks for the very helpful video. Bought a used griz and am a bit new to it. Got the brakes done with confidence. Watching the vid made it very easy. I will be doing the bearings this winter so I've already watched that one. Any other maintenance vids you put on for griz I will watch. Helps to know exactly what tools a guy needs before starting. Thanx again.

[@flysubcompact]

Excellent video. Thanks for the effort

[@gurjitbhullar9068]

Very helpful thanks, young man.

[@eclipser2004]

Do those allen bolts that go through the pads need any brake lube? Mine were a bit corroded and sticky. Also the pad hooks over another rod on one end and that looked a bit sticky too.

[@LilasTools]

eclipser2004 I always lube caliber pins, make sure to silicone brake lube though!

[@robertsullivan9501]

great instructions, I have a 2006 Yamaha 660 grizzly and am wondering if you are going to do more on that machine, I am interested in gravity flushing front and rear brakes/rebuilding front & rear master cylinders and anything else that pertains to that model machine

[@mikeduplessis708]

robert sullivan

[@uberleet01]

The hex bolts are seized. Any tips?

[@2291225alan]

Hi I got 2001 yamaha grizzly 600 4x4 its the brake same to this one?

[@jayonez137]

You should really wire wheel the retainer pins and also re grease the slider pins

[@TheUberGopher]

When you pop out the rear brake pin and can't find it on the floor or in the belly pan, look in the plastic air tube. That there is experience talking....

[@alexandrbyelan6504]

Thenks!!!!

[@dougbreakstone8780]

I'm looking at a 2006 grizzly this weekend. Can you tell me what I should look for ands the weak spots to look at for. Thanks

[@TheUberGopher]

Front drive shaft splines. The splined shaft is short and the splines tend to wear out. I had a rear axle pop out, they are only held in by a spring pin. You can pull it all apart and bolt the two inner axles together.

[@rayg3074]

good job

[@landongall2080]

Thank you

[@janko7771]

Thanks

[@broswithbows2230]

your welcome

[@EpilepsyWarning]

my welcome?

[@zionbldrs1582]

How did you compress the rear caliper pistons?

[@TheUberGopher]

Just stick a pry bar in there.

[@rayg3074]

thumbs up

[@scottd3532]

I just did my rear brakes on a 2005 kodiak but I did it from the side not the back..why would u do them from the back?..I tried..lol..made no sence too me

[@rayg3074]

good job