2007 Honda Accord AC Blend Door Actuator Replacement

[@yourcruiseplanner]

Thank you! Saved $400 doing this myself and couldnt have done it without this video. Tip: Pay close attention to the part where he sets thermostat to cold before installing. I missed that part and spent 30 minutes trying to figure it out. Watched again, saw it. Easy after that.

[@thomasfixit7931]

I'm always glad to hear when people saved themselves money!

[@alfredoverno9674]

this is the best video on this subject. well made and to the point. thank you sir.

[@thomasfixit7931]

Welcome! Glad it helped!

[@alfredoverno9674]

@@thomasfixit7931 the best advice was to remove that 12mm bolted bracket, and set the controls to "coldest". I'm hopping in there now. I hang upside down on the driver seat, almost passed out. haha

[@jumpingjake123]

Thanks dude! This is exactly what I needed!

[@thomasfixit7931]

Glad I could help!

[@flowman777]

just did it but i took off the small screw's on the front part where the clip is not the top one..worked

[@thomasfixit7931]

Glad you got it working.

[@Piccodon]

The bracket does not wear out so keeping that in place makes it easier to replace. The window "regulator" on the Accord even has a keyhole on its bracket to help installing it so the top bolt does not need to be removed.

[@michaelzayas2347]

Feel like my rear defroster is defrosting i changed the fuse, just wanted to know if one of these blend door help it for the rear

[@joefabela9267]

Gonna try this and I'll come back to let ya know if it worked 😅

[@The495marauder]

Any updates? Which car are you the replacing the part on?

[@FlareArreglado]

Hello Thomas, thank you for this video. Very informative. I really want to know what exactly tools and sizes did you use to the screw and other volt. I am planning to remove mine and replace it. Thank you Thomas! Its the same right of my Honda Accord 2007 V6

[@thomasfixit7931]

I show the tools and talk about the socket size in the video

[@FlareArreglado]

@@thomasfixit7931 Thank you so much! God bless.

[@The495marauder]

I’m getting uneven vent air conditioning temperatures. The passenger side seems to be fine. But the drivers side is blowing warm air. My drivers side actuator goes up smooth and effortless for heat however for the ac it goes down far enough for the air to blow but hesitates and stops. Does that indicate that it’s stuck and the actuator is bad???

[@thomasfixit7931]

You may just need to charge the a/c system. Check out my other a/c video

[@planchik]

is this the part that controls temperature or the direction of which vent the air is coming from?

[@thomasfixit7931]

This one helps control the temperature, the one that controls the direction is behind the glove box

[@planchik]

@@thomasfixit7931 so on my 07 accord, the driver side blows hot and passenger blows cold. then this one would be the one to replace or the one behind the glove box?

[@scirishrugger]

Is this what controls the cable that goes under the hood that moves to allow coolant into the heater core when you turn the control from cold air to hot air?

[@thomasfixit7931]

No, it controls the flow of air.

[@scirishrugger]

@@thomasfixit7931 meaning if it comes from the top or bottom vents?

[@fahedmahases723]

hey. I found out that my blend door aculator is out of order/cycle. I searched so much on KZbin and google. My aculator would think that it is on max cold or hot but be on the wrong direction it is pointing at. When I try to align it to the flips it does not match/fit. Is there any way to rest the aculator. Thank you for you support.

[@thomasfixit7931]

Sounds like you just need to replace the old one.

[@joshfreedman2519]

Did you end up finding a fix? I had a factory actuator and replacement actuator both rotate the same way out of the normal sweep. They wouldn't rotate down all the way to max cold but would try to over-rotate up past max hot. I'm not sure if there is a procedure to set the actuator back to the factory range of rotation.

[@fahedmahases723]

@@joshfreedman2519 no I just sold the car

[@joshfreedman2519]

@@fahedmahases723 I'm about ready to do the same lol. Thanks for the reply!

[@fahedmahases723]

@@joshfreedman2519 😂😂😂

[@m0bin2]

I see your check right door sign is up on the dashboard.. Does the fix also fixes that ? I have the same problem. I clean both front and rear blend air mixture both are working now, I have reset the #7 7.5amp fuse but the Right door is still not working. The DTC codes I get are B2080 and B1233. Any help is much appreciated

[@thomasfixit7931]

Seems like you have multiple problems and hard to figure it out over KZbin.

[@ClearViewSolutionsMS]

Mine is not allowing the air to divert to the defroster. Is this the same motor?

[@thomasfixit7931]

Check the actuator behind the glovebox

[@keithmahler4236]

mine is making a knocking noise when turned on so would this be it on 2006 Honda accord

[@thomasfixit7931]

I don't know. Look at the actuator when you switch the setting.

[@JuanGarcia-km1nc]

I put mine cold but it blow hot on the passanger side is this the same problem?

[@thomasfixit7931]

Does it blow cold on the driver side?

[@MrCt302]

My blend motor on the right side is not getting any power.. What can that be?

[@thomasfixit7931]

Did you check the fuse?

[@isaiahsalazar7508]

There’s no need to remove bracket to access screw.

[@thomasfixit7931]

How did you get the screw out without removing it?

[@marccowvins856]

Awesome

[@thomasfixit7931]

Thanks!

[@jamesbailey8790]

On the drivers side...correct?

[@thomasfixit7931]

Yes. I put in the description, forgot to say in the video.

[@thomasfixit7931]

@@pleco101 Check out this video kzbin.info/www/bejne/mpWwo3mffM9qZtU

[@SaulGude]

Could you just manually lock this in the cool or hot position? Or will it not move without power?

[@jeremywarren7838]

Wat is the part #

[@thomasfixit7931]

I don't remember.

[@daniyalahmed4335]

part number or link please

[@kirbytabor9956]

Part number????

[@thomasfixit7931]

I don't remember. Just look up your make and model.

[@jumpingjake123]

Thanks dude! This is exactly what I needed!

[@thomasfixit7931]

Glad it helped!

[@phansenh3060]

Mine is blowing cold air on driver side but hot air in passenger side, is this the same process I need to do sir?

[@thomasfixit7931]

Not sure without looking at the car