Julio! My Mazda 6 does this not often but sometimes! HOW WOULD YOU REMOVE OIL FROM SPARK PLUG CYLINDER
@DRBauto2 жыл бұрын
Is the oil inside where the spark plugs before you remove it? If it is then replace the valve cover gasket.
@breadchaser31514 жыл бұрын
Can you tell me why there is 2 Cabela's on the plus side?
@DRBauto3 жыл бұрын
1 cable may possibly be directly to starter and the other is to main fuse box to alternator.
@Woozwins2 жыл бұрын
My car does this right now with the lights what do I do?
@DRBauto2 жыл бұрын
Replace the battery terminal connector or if you want to settle with this same like on the video. Remove the wire, clean the area were the wire goes in place really good with a steel brush. The resecure the wire if it is still loose find a small material that will fit in were the wire goes to help make it tighter.
@Woozwins2 жыл бұрын
@@DRBauto thank you so much I’ve been in dire need of help if you could contact my email so i could show you the problem I will very much appreciate it
@DRBauto2 жыл бұрын
@@Woozwins scyaint@gmail.com
@comiu Жыл бұрын
How is this car idling at 750 rpm after not starting for a while?
@DRBauto Жыл бұрын
What do u mean?
@comiu Жыл бұрын
@@DRBauto from what I know a car idles higher when it's cold and the idle speed drops to around 600-900 rpm when it warms up. This car idles at 750rpm from start up,even though it has not been started in a while
@DRBauto Жыл бұрын
@@comiu I had i jumped to pull it in the shop. And that is why its warm already and idle normally. But the condition of the car is no start and needs to be jumped all the time
@Woozwins2 жыл бұрын
And how was the car fixed?
@DRBauto2 жыл бұрын
I replace the battery terminal connector, as long as you have a strong battery.
@joeishere5003 жыл бұрын
My Mazda still sitting in shop waiting for a starter. It's a 50 / 50 chance it's electrical . They sure don't know how to troubleshoot at a Chain-place where my car is at ...
@DRBauto3 жыл бұрын
if you can describe more of what is happening to the car.
@joeishere5003 жыл бұрын
@@DRBauto ,, left inside lites on , jumped it no problem 1 hole day later , it not start after 20 minutes of driving. Bought new battery , all lites on dash are good , fuel pump works. No clicks. Towed to a larger franchise chain , said pulled out starter an cylinoid fried but not really test fuses etc etc . Makeing excusses not recieve a new mazda starter yet. Been 3 weeks .
@DRBauto3 жыл бұрын
Wow, well it can happen that starter burnt because of repetitive craning while trying to start the vehicle. In this case strter really need to be replaced before proceeding to the next step. I may have another experience in this car on a 4 cylinder engine that the timing went out of time causing the stalling and no start.
@joeishere5003 жыл бұрын
@@DRBauto ,, yea thanks for the reply Julio. From videos its a 50/50 shot its the starter. Its a 2007. Been good to me. Sucks though the 1st shop bringing too they suck an not really trouble shooters ya know .
@CHIBA280CRV4 жыл бұрын
They try to save money now and pay more later..
@DRBauto3 жыл бұрын
true
@gustavoares1704 жыл бұрын
don't be silly, you are alone and taping yourself! don't use face mask for that, since it makes harder for people to understand what you say!
@DRBauto4 жыл бұрын
I am recording myself yes :) And thank you for the advice, i will take masks off next time.