Put as much effort into your craft as you do to your videos, you'll do great. .Learning computers is part of your craft now in case you didnt know. I'm not being the dick, your car manufacturers are. Best of luck bud.
@lakesautomotivediagnostics65096 ай бұрын
I could see leaving a comment like this if I should have done some testing that I did not do but in this particular case, I did not diagnose the vehicle. The lady brought in her own crank sensor and just wanted it installed. Thanks for watching. Hope you have a great day.
@faisalameer738 ай бұрын
❤ informative
@lakesautomotivediagnostics65098 ай бұрын
Thanks for watching
@billycurtis5788 Жыл бұрын
Dura junk! lmao love your content bro!
@lakesautomotivediagnostics6509 Жыл бұрын
Appreciate it. Thanks for watching.🔧😃🔧
@CEDD9136 ай бұрын
perhaps thats why they give a lifetime warrtany on thoses parts
@manny41384 ай бұрын
@@lakesautomotivediagnostics6509 my dumb brother got a durajunk one my Honda is throwing codes and going into limp mode
@manny41384 ай бұрын
Going to order one from Denso
@lakesautomotivediagnostics65094 ай бұрын
Sounds like a good idea ,
@amvilla20088 ай бұрын
Is it absolutely necessary to re-train the crank pattern with a new sensor? Or can you just swap the sensor and clear the code? I JUST had this go out on my Accord
@lakesautomotivediagnostics65098 ай бұрын
You might get lucky, but I always relearn them
@GainingDespair8 ай бұрын
Any possibility one could leave the vehicle disconnected from battery to reset crank values?
@lakesautomotivediagnostics65098 ай бұрын
I could see it, possibly clearing the value, but not learning the value
@sebastianmaulen11829 ай бұрын
What scanner you using bro
@lakesautomotivediagnostics65099 ай бұрын
Snap On Zeus
@biggiefitz6275 Жыл бұрын
👍👍
@lakesautomotivediagnostics6509 Жыл бұрын
Thanks for watching 😃
@hardrockreviews8537 Жыл бұрын
Brother where i can get this duralast do u have any link for it
@lakesautomotivediagnostics6509 Жыл бұрын
Duralast is Autozone
@bulldog91vs Жыл бұрын
Would it work without that screen machine you used
@lakesautomotivediagnostics6509 Жыл бұрын
you will probably be fine, but I do this with every crank sensor I change, thanks for watching like and subscribe
@bulldog91vs Жыл бұрын
No doubt good video bro
@sebastianmaulen11829 ай бұрын
@@lakesautomotivediagnostics6509 what scanner you using
@REALAMERICANMAN53110 ай бұрын
If they were smart enough to buy their own part. Why not just install this thrmselves. This seems ez as hell to me.