2011-2016 Honda CR-Z Front and Rear Brakes and Rotor Replacement/Removal

[@TheTheedad]

The emergence brake cable relief . That's what i needed to know.

[@marioruisilva]

You said "don't forget this little Y spring" and then you forgot it.

[@kingmonkey88]

How not to do a brake replacement...

[@Noble_jay66]

Do you not have to bleed the brakes on these if you do it that way?

[@TommyMccoyMedia]

This was super helpful! Thanks bro!

[@arroncorney8314]

Always copper grease the rear side pads stops squeaking lol

[@harryw9598]

dont hang your caliper on the brake line its to much stress man.

[@josefermalino461]

U need to use JIS screwdriver for that to remove

[@enyerrivers5151]

This was a horrible tutorial. No anti seize lubricant used. Didnt even use new clips and even the Y springs. Also didnt even explain the rear properly. Was too short

[@jordancasey9594]

Very nice video but you did not show how to replace the rear. They are different and have a screw in piston compared to the slide in ones on the front.

[@spintheboost8888]

@ Jordan Casey, thanks for your comment I would suggest that you look at minute 9:45 of this video where I go over the rear brakes including the different type of piston.

[@the_observer9786]

Dude wtf what kind of grease for the caliper pins? What kind of grease on the back of the pad? Torque spec for the bolts? Horrible video

[@SONICBOOM-117]

Bro you sped through the video man. Ppl wanna see .

[@voiceofthemachines]

Those bits don’t work for shit