2011 Audi A4 2.0T CVT transmission fluid and filter replace / add.

[@pizon75]

I had slipping problem after oil change. They did not change oil filter which got clogged and caused low oil flow. You have to change oil filter every time you change oil because new oil will wash away dirt and other particles stuck on the walls and parts of gearbox components. That s why is soo important to change it on regular service intervals recommended by manufacturer. If you let it go too much driven over recommended service interval its better to do it 2 to 3 times oil and filter change in short intervals to wash out all dirt inside and get caught by filter. This is my experience.

[@flaviurosca5912]

The adapter for filling its ATF107?

[@elvrolet]

Yes, 107

[@classicfellow1059]

How do you drain it initially? I removed the plug cold but only 1L came out?

[@elvrolet]

The initial drain is just the drain plug. Then pull out the plastic cone that is up in the hole. Whatever comes out is all you can get out.

[@PetesWorkshop]

Hey mate. Great vid. You mentioned you already did a ‘flush’. How did you do that?

[@elvrolet]

I should have said Drain instead of Flush. As mentioned in the video, removing the drain plug, then removing the Fill Level Tube and letting it pour out. That is what was done at a prior time before getting to this video process.

[@allanj.p3663]

How long did this take you? Is it possible for anybody to get it done?

[@elvrolet]

The whole process start to finiah was about an hour. The important piece is having a way to read the trans fluid temp so it is filled correctly. Everything else is just following instructions like normal.