2012 Ford Focus no crank no start. Easy repair!

[@dodgeking9194]

Nice to the point video instead of spending most of the video gabbing about unrelated stuff

[@agustinmarquez2518]

Thank you buddy. I swapped out transmission but now have exact same symptoms as you. I will try that. Wish me luck

[@dieggogoncalves874]

Did it work out for you?

[@agustinmarquez2518]

@Dieggo Goncalves well buddy I'm trying to buy the sensor. I had the old transmission on my yard where I was working on my car and I guess some scrap metal picker took my old trany. Damn I had the tcm and a few other parts I wanted to get off that trany before trashing it. Damn metal scrappers are out of control around here

[@seetaseelal4793]

I have a problem with my Ford Focus see me automatic transmission I looking for the neutralizing switch

[@nevadapeet2929]

Whoa there, Why would you cut that when you could have just unclipped it?

[@DLMGarage]

In case my connector was bad. The harness in the donor car was already cut and junk. Had the harness not been cut I would of not cut it so so eone else could of used it.

[@carlossoltero8015]

🤔 If that was the first time the car was ever started, why was the car temperature gauge in the middle ?

[@DLMGarage]

faulty sensor, it was another problem I found.

[@BattleWizard_1]

Whats the name of the part, and where to purchase the part for the PRNDL situation

[@DLMGarage]

neutral safety switch, i got it at a junk yard, you can try rock auto

[@jordynharris5052]

I have the same problem sometimes my car will start sometimes it doesn’t read that it in any gear

[@DLMGarage]

This part might be it

[@tinnakornsai4404]

DIY PC MODS Now you doing cars too? keep up good work.

[@DLMGarage]

Thanks, cars have been my side hustle and hobby for years, figured might as well record that too!!

[@BattleWizard_1]

Are the codes you mentioned correct? P0707 and P2802

[@DLMGarage]

yes

[@machinistsaudia6630]

I have same problem my 2012 ford focus. Are you sure that nuteral safety switch is bad

[@DLMGarage]

it can be that or a wiring issue. I confirmed the switch by checking powers and grounds. biggest red flag was the no prndl display

[@lifeastruggle8600]

What’s that part called ?

[@DLMGarage]

range sensor

[@justinoneel1654]

I have this exact problem. I swapped out the engine and now it doesn't show what gear it's in and no crank/no start. I replaced that part but it didn't fix it. Any other suggestion? I'm not getting any codes either 😕.

[@DLMGarage]

When I did the swap I forgot the ground thats around the transmission.

[@MrJesus4194]

Same problem, mine happened to be that one of the two big plugs that connect to the tcm was not seated properly.

[@steveciezkowski4573]

get the clutch fork tool and you need a scanner to do relearn on tcm

[@albertvargas2694]

How do you Un clip it having a hard time trying to unclip that mf

[@DLMGarage]

I used a small screwdriver and prayed the clip back while pulling up

[@jacobharris6546]

Can I please have your tcm

[@DLMGarage]

kind of need it for my vehicle to run....

[@jacobharris6546]

I meant the one from the junkyard you were showing off 🤣