Is the 2.5 volt bias suppose to be there even with key off? I was thinking maybe an ignition switch issue at first
@Drescars Жыл бұрын
Key on for the bias… I was going to check switch but than I saw activity on CAN line… witch made me think switch was ok…
@puresoulg8 ай бұрын
What did you actually do to get the Truck Communicating ❓
@Drescars8 ай бұрын
Unplugged the module under carpet on passenger side it communicated and started I had to cycle the key. Then I purchased a used one on EBAY. The ABS light was on after that and it needed an ABS module that had to be programmed. Good Luck 🍀👍
@moemoe48210 Жыл бұрын
U shouldn’t be able to release key to?
@alexquintana905 ай бұрын
Mine is 2014 ecodiesel, says ignition or accessory on and it won't start, can anyone help me out with some tips!! I'm sooo disgusted with Chrysler and ram!!! Battery showing 12 volts.
@Drescars5 ай бұрын
First thing I do is run a full scan with a good scanner… all the modules then check the starter also the main engine ground. Make sure your test light is connected to the battery… I hear you about Dodges, and the newer ones are absolutely crap!! Good luck man!!!
@rickjames58347 ай бұрын
Is it me or dose the 2013 rams have a lot more issues then normal
@Drescars7 ай бұрын
You are correct 👍 to me they are very problematic… specially with their network…
@moemoe48210 Жыл бұрын
TIPM or car isn’t in park fully💀
@erikaorvald37356 ай бұрын
I need help. Same year 2500
@Drescars6 ай бұрын
What’s going on? No power with key on?
@738-r5j5 күн бұрын
Well that's 12 minutes of my life I'll never get back you ran your mouth and ran your mouth but you never said what was wrong if you want to babble just to hear yourself go stand in front of a mirror
@DrescarsКүн бұрын
Well buddy, I don’t have a crystal ball and I had a truck with no power to anything, no communication or power until I unplugged the drivetrain control module… If that didn’t ring a bell, then not sure if any video can help you!!! The truck runs on the second video… Good luck with the parts cannon!!!