2014 HYUNDAI SANTA FE, CLICKING NOISE IN THE STEERING WHEEL

  Рет қаралды 12,264

Hyundai Tech

Hyundai Tech

Күн бұрын

Пікірлер: 59
@shabazhussain3367
@shabazhussain3367 2 ай бұрын
Hi i see you reply to comment much appreciated I have a 2017 santa fe replaced this part but still have same issue also checked the coupler. Thanks
@hyundaitech
@hyundaitech 2 ай бұрын
Did you check first the outer tie rod or inner tie rod or the steering rack? If they are all good and the mounting bolts for the universal joint is good and tight most likely the steering column issue, and i believe those 2017 santa fe models doesnt have those rubber coupling like the sonata. Hope that helps.
@forbro8301
@forbro8301 Ай бұрын
I wish I understood what exactly you were marking. I don’t understand what you were marking to have a reference for. I’m gonna try to do this on my 2013 Santa Fe soon.
@hyundaitech
@hyundaitech Ай бұрын
I was just marking the position of the joint so that i dont have to recenter the steering wheel or do an alignment
@meylehoodghana3456
@meylehoodghana3456 Жыл бұрын
Great explanation
@PinoySilverback
@PinoySilverback 2 жыл бұрын
Kamusta? I have a 2014 Santa Fe Sport. May knocking sound when turning the steering wheel especially when turning at low speeds.
@hyundaitech
@hyundaitech 2 жыл бұрын
But if you move the steering wheel from left to right and vice versa on park does it make the same noise? I would check the suspension first especially if you said at low speed, if suspension and steering under the car is good, then check universal joint, park and move the steering wheel.
@PinoySilverback
@PinoySilverback 2 жыл бұрын
@@hyundaitech thanks for replying. It makes the same sound while in park. It's not very loud. I had the steering components (tie rods, joints, etc.)checked by two mechanics. Theh both said everything is good and tight.
@hyundaitech
@hyundaitech 2 жыл бұрын
@@PinoySilverback like the way i did on the video, carefully place your hand on the joint ( make sure be mindful of your fingers) then turn the steering wheel if the universal joint is faulty you will feel some play on the joint, or if you visual check it if theres some grease coming out from the joint and yeah you have faulty universal joint.
@PinoySilverback
@PinoySilverback 2 жыл бұрын
@@hyundaitech Thanks!
@PinoySilverback
@PinoySilverback Жыл бұрын
​@@hyundaitech 5 months ago I had this checked at the dealership. They found that the bolts were loose. After tightening the sound went away.
@pegasus75
@pegasus75 Жыл бұрын
Hi, did you remember the part #, or where you get the Part# and order from? I ordered one for my 2013 Hyundai Santa Fe base sport, part # 56400-4z000 according to hyundai website, but when I received it, the joint is too short for my car (when the joint is fully extended). The old one seems to be longer. any help will be appreciated. Thx
@hyundaitech
@hyundaitech Жыл бұрын
Whats your last 8 of the vin, maybe i can help
@pegasus75
@pegasus75 Жыл бұрын
@@hyundaitech DG086570. According to online Hyundai parts, the part # is 56400-4z000, but when I received the order, the shaft was too short. Not sure if this is limited edition. Even the Power steering motor is an updated version without the rubber coupler. Thank you again for your help. I really appreciate it
@hyundaitech
@hyundaitech Жыл бұрын
@@pegasus75 hi the part number you provides is correct when using your vin number its 56400-4z000, unless theres a supersede number so best way is ask from dealer if theres a different part number for that part. Hope that helps
@pegasus75
@pegasus75 Жыл бұрын
@@hyundaitech yeah I think you are right, something is definitely not right lol..thx again for your time.
@pegasus75
@pegasus75 Жыл бұрын
Hi, finally got the right part #, installed everything just like you did except I have to remove the MDPS module for better access to the bolt, anyway after I put everything together, there is a "bearing" noise that definitely comes from the steering column when I turn the wheel left and right. Did I miss something? No EPS light, the clock spring seems to be fine. I even grease the steering shaft a bit. Sorry to bother you, just hoping you can guide me to the right direction. thx again
@Captobvious23
@Captobvious23 Жыл бұрын
Hi I was wondering if there's a way to determine if you're steering wheel is straight with a scan tool
@hyundaitech
@hyundaitech Жыл бұрын
Yeah you can check by reading the stearing angle. But the best way is thru alignment.
@Captobvious23
@Captobvious23 Жыл бұрын
@@hyundaitech Thanks for the info I have another question for you I have 147k on my 2013 Hyundai sonata turbo when should I consider changing the cam follower on the high pressure fuel pump Thanks again
@hyundaitech
@hyundaitech Жыл бұрын
@@Captobvious23 hi usually those components are lifetime, as long you do oil change regularly.
@Dpbherrmann
@Dpbherrmann Жыл бұрын
Is the clicking sound only appearing when the car has been driven a while? That's my case.
@hyundaitech
@hyundaitech Жыл бұрын
No it should all the time, and if you park your vehicle for awhile then try to start it then move the steering in either direction you usually hear a one click or something like that
@leecelis4712
@leecelis4712 9 ай бұрын
Hello good day, I have a similar problem. Can I still drive the car till this problem is sorted? Many thanks
@hyundaitech
@hyundaitech 9 ай бұрын
Yeah you can still drive the car, as long joint is not falling apart. If its just noisy yeah it can wait a little bit until you fix it.
@leecelis4712
@leecelis4712 8 ай бұрын
Many thanks, you're the best.
@MrAntoha78
@MrAntoha78 Жыл бұрын
Hi Hyundai tech! I used your professional skills to detect problem on my u joint. Now when I disconnected shaft I didn’t disconnect the battery. In the process I must have turn steering wheel couple of times one way or another cause it wasn’t connected. When I installed new shaft the dash come with eps warning red light and also electronic stability control and down hill brake control lights show yellow. My question : is it because I was playing wit the de attached steering wheel and can it be fixed by connecting it to the diagnostic computer? Regards Anton
@hyundaitech
@hyundaitech Жыл бұрын
Yeah most likely when you remove the joint,. When you put everything back together was the steering wheel straight with the tires? Maybe try to straigthened the tires and the steering wheel together. If still doesnt work you need the scantool to monitor the steering angle and make it to zero then disconnect the u joint then the straight the tires, then reinstall everything. Hope that helps
@MrAntoha78
@MrAntoha78 Жыл бұрын
@@hyundaitech thank you Sir! I really appreciate your help. Meanwhile it’s drives normal as usual. Can I drive it for 7- 10 days before go to the garage to fix? Cheers
@hyundaitech
@hyundaitech Жыл бұрын
@@MrAntoha78 with the warning lights? It drives normal without warning lights? If yes, yeah you can drive it
@MrAntoha78
@MrAntoha78 Жыл бұрын
@@hyundaitech I think I damaged clock spring. That explains lights on the dash and buttons on steering wheel is not responding. Was turning disconnected wheel to much
@hyundaitech
@hyundaitech Жыл бұрын
@@MrAntoha78 oh no, let me know when you fox it
@gabitorivera9344
@gabitorivera9344 Жыл бұрын
Helloo sir if I see grease leaking it’s bad?
@hyundaitech
@hyundaitech Жыл бұрын
If its making noise and the noise is coming from there and yeah its bad.
@gabitorivera9344
@gabitorivera9344 Жыл бұрын
Mines makes like a grinding noise
@edm2031
@edm2031 Жыл бұрын
What is the part number ?
@adolfomabalot7424
@adolfomabalot7424 2 жыл бұрын
Are you in the philippines sir
@hyundaitech
@hyundaitech 2 жыл бұрын
No sir, canada hehehe
@adolfomabalot7424
@adolfomabalot7424 2 жыл бұрын
@@hyundaitech kala ko sir sa pilipinas ka hirap kasi magpagwa dto sa atin kng kani kanino nagbabayad ka nmn ng maayos palpak nmn ang gawa yng sta fe ko sir may mahina sound na ganyan sabi mormal lng daw?
@hyundaitech
@hyundaitech 2 жыл бұрын
@@adolfomabalot7424 suggest ko, as long as its not safety issue, jist monitor it for now then if it gets worst atleast now you are sure that its coming from universal joint.
@PinoySilverback
@PinoySilverback Жыл бұрын
@@hyundaitech Whoa! Where in Canada? Malapit ka ba sa Kitchener bro?
@hyundaitech
@hyundaitech Жыл бұрын
@@PinoySilverback toronto man
@daddyxian9773
@daddyxian9773 Жыл бұрын
nawala ba yung ingay? minsan nararamdam ko ganyan sa lubak.
@hyundaitech
@hyundaitech Жыл бұрын
Yes, and its gonna be louder over bumpy roads.
@daddyxian9773
@daddyxian9773 Жыл бұрын
@@hyundaitech thank you sir. medyo mahal yung parts na yan satin nasa 7k +
@hyundaitech
@hyundaitech Жыл бұрын
@@daddyxian9773 yup mahal talaga
Knocking Noise When Turning Wheel  - Hyundai & Kia - How To DIY
10:23
Steering Wheel Problem!  Hyundai Sonata 2011-2013 (YF)Steering Column Noise
27:02
Rainman Ray's Repairs
Рет қаралды 170 М.
Я сделала самое маленькое в мире мороженое!
00:43
HELP!!!
00:46
Natan por Aí
Рет қаралды 12 МЛН
Human vs Jet Engine
00:19
MrBeast
Рет қаралды 162 МЛН
Fix Steering & Suspension Noises or Sounds - Clunking Shaking Vibrating
7:21
BBC Presenter WRECKS Israel’s Spokesman, Video Goes Viral in Britain!
20:56
OpenmindedThinker Show
Рет қаралды 914 М.
Hyundai and Kia Steering Wheel Clunk Fix
15:39
Ratchets And Wrenches
Рет қаралды 80 М.
GOT CLUNK? HYUNDAI/KIA ELECTRIC STEERING FLEX COUPLER
12:27
Build Something Stupid
Рет қаралды 105 М.
Replacing Tie Rod Ends 2013-2018 Hyundai Sante Fe
8:29
Tech28
Рет қаралды 1,5 М.
Top 5 reasons why the suspension knocks | AUTODOC tips
8:14
autodoc.co.uk
Рет қаралды 1,4 МЛН
Creaking Noise when turning diagnose
15:24
Basic Detail
Рет қаралды 719 М.
Top 5 Problems Hyundai Santa Fe SUV 3rd Generation 2013-18
3:27
1A Auto: Repair Tips & Secrets Only Mechanics Know
Рет қаралды 709 М.