2014+ Tundra Rear Bumper Installation Guide

[@stevewells2425]

Great job guys. All C4 products I've found to be well made attractive and easy to install. Tacoma and 4runner both have C4 sliders and front lopro bumpers. Now its time for the tundra.

[@c4fabrication397]

Thank you for supporting us, glad you like our products!

[@tonydijock151]

@@c4fabrication397 can you cut that lip that you hammer down? I feel like I’d get more room to make mine flush

[@joejr9653]

Not a bad looking bumper. Definitely could be made better. Redesign the license plate area to allow the trailer pin connector to go next to license plate so your not stretching the connector to plug it back in. Provide cutouts to allow license plate lights to be used from stock bumper.

[@demarkiowilliams]

Great job on the video and detail, very thorough. Awesome bumper too!

[@c4fabrication397]

Thank you!

[@tonydijock151]

What about the blind spot sensors?

[@rayrayk7458]

This is a real late post, but I've been looking all day about the wiring for the license plate lights. I have a 2019 Tundra and have the green and white/black wires. When I tested, green didn't come back current. The white/black did. So I figured that was positive. But the light didn't work. This video is the only one I found that said green goes to the red and the white/black goes to black. That's how mine worked too. But shouldn't black go to green for negative?

[@AggiePhil]

So you lose the blind spot monitoring and rear cross traffic alert capabilities?

[@HBButler01]

Make this for 07-13 Tundras also! Both Gen Tundras need some beefy stuff like this!

[@spreadcreekjr1731]

Bad ass

[@nathancruz9070]

Might as well keep your stock bumper. It’s the same ground clearance, at least oem fits better