2016 Ford Escape AC Condenser removal tips. Not a walkthrough but most the critical steps.

[@GreyRockOne]

Good to know, there are other videos that show in detail how to remove the front bumper cover but yours was good because I need to remove my intercooler to clean out all the leaves and debris crap between that and the AC condenser, otherwise it will just corrode both items, so essentially I have to go through all this dismantling, no problem, I'm up for it. Thanks again!

[@SabynBrokeWhat]

This works for 2019 as well best video ive ever watched thank youuu

[@schmitttuning1895]

i just finished doing a condenser on a 2019 ford escape with the 1.5. if you can get the front wheels of the ground and removed, you can peel back the wheel liners to gain access to the fender screws that hold the bumper. 3 on each side. on the 1.5 engine, once you remove the bumper cover, the fan shroud with the built in louvers, the intercooler(will have to draim the coolant), you can slide the condenser down it come out from the bottom

[@Ionwe]

This has been incredibly helpful and I'd just like to thank you for making the video and taking the time.

[@ykmalachi]

Thanks.

[@mikegriego3671]

I'm changing a condenser on a 2014 escape. It helps a bit.

[@TheBrandolicious]

do we have to replace the condenser? what happened to the old days of compressor, accumulator & oriface tube?

[@willl.5260]

Can radiator be removed without removing condenser?

[@ykmalachi]

I think so.

[@AZ-pk4gk]

No, I just tried, no luck. I ended up damaging the Condenser. No short cuts also. Whoever design and engineered this is stupid.

[@willl.5260]

It can. Check my channel. I posted a video detailing it.

[@AZ-pk4gk]

@@willl.5260 good for you!

[@njheflin1583]

Stinking Ford…always gotta make it a pain. Did an F150 the other day, what a pain!

[@technicalitems731]

Gawd dam. Are the Hondas and Toyotas just as bad? Wtf??? My gf has a 2016 escape SE. Awd. A/c just quit. 170k miles. Found this video. Wtf

[@ykmalachi]

Most modern cars require front end removal to get the condenser out.

[@mikegriego3671]

I'm changing a condenser on a 2014 escape. It helps a bit.