2017 F250 & F350 Bushwacker Pocket Style Fender Flares Install

[@bigguy1403]

Do you happen to remember what that color gray was called?

[@KyleMayad]

Ashton Grey

[@bigguy1403]

@@KyleMayad thanks but I sold it 2 days ago..

[@thatguy5915]

What are the wheels and tires on this truck?

[@stage3motorsports]

Fuel Maverick 20x10" D538 Wheel (-12mm Offset) and we have had both 35x12.50R20LT Toyo Open Country M/T Tires, and 37x12.5R20 Toyo M/T's Check out the build details here - www.stage3motorsports.com/Stage-3s-2017-F250-6-7L-Super-Duty-Project-Truck.html

[@thatguy5915]

Thank you! They look perfect with the flares.

[@Khaled-tx5xj]

How much flare does this give the superduty ?

[@project.jericho]

1.8 inches.

[@garrettcooke5566]

How is axle rap with lift? Would it be better with the recoil traction bar from bds?

[@jjsilversmith]

This video doesn't give nearly enough detail on the install. It took me 6 hours to put on the four fender flares because of poor hardware, poorly drilled holes and bad design.

[@bendover-yr4oq]

Jason Smith at least they took the time to make a video 🤷🏽‍♂️. You act like it’s there fault it took you 6 hrs 😂 on a product that’s not there’s

[@project.jericho]

@@bendover-yr4oq Your name is apt... There's no reason to take it in the ass for any company; if you're going to make an installation video, do it well.

[@chadtherriault6508]

The factory hardware is junk. Had mine dealer installed 3 times, and had to re paint the truck because the don't mount tight and rubbed the paint off. Final time I installed them using riv nuts and 3m double stick tape in place of the rubber seal.

[@Subi_doo]

Don’t use detail spray. Use a wax an grease remover before installing