Thanks - I just could not figure out how to get the lens out, and didn't want to risk breaking it. I had taken out the center panel trim (sunroof controls between the two lenses) when I got stuck and looked for help. That helped replace the first lens that I took out - I kinda sorta inserted the lens cover from the center and it slid into place easier than trying to push the lens in from the side. You could have done it one handed. Then taking out the second lens was even easier tugging it to the center, than I'd found taking out the first one toward the rear of the car. So much happier with new LED bulbs!
@JimMcLaren19504 жыл бұрын
Your welcome Terry. Yes I was worried about breaking the Lens as well.
@danielrobert7181 Жыл бұрын
Those festoon type bulbs come in a variety of lenghts. The ones you installed in the map lights holder must have been a millimeter or so off !
@JimMcLaren1950 Жыл бұрын
Thanks for posting. They were off a bit.
@tutubodan5 жыл бұрын
thank you Jim for the information and showing how to replace the lights.
@JimMcLaren19505 жыл бұрын
Your welcome.
@bmws4sale Жыл бұрын
Dammit , I found this after I had to figure out how to get the front dome lights out lol. 😂
@Align700nitro4 жыл бұрын
Now that's a proper installation. But be careful, don't use aftermarket LED for Subaru, unless the resistance is the same. Otherwise you can burn the BIU (body Integrated unit) overtime and that is going to be real expensive.
@JimMcLaren19504 жыл бұрын
Thank you. Thanks for posting about after market led.
@Amir_Hassan3 жыл бұрын
hey Jim! do these fade on and off slowly similar (for ex when locking the car) to the original bulbs?
@JimMcLaren19503 жыл бұрын
Didn't notice my led fading on and off.
@westcoastclutch3604 жыл бұрын
thanks guy!
@JimMcLaren19504 жыл бұрын
Your welcome.
@MrEvilTag2 жыл бұрын
Gloves? Seriously dude?
@JimMcLaren19502 жыл бұрын
Wore gloves so I wouldn't to protect the led lights from oils from my hands.
@MrEvilTag2 жыл бұрын
@@JimMcLaren1950 if you hold it properly its not a problem
@ZombieDawg2 жыл бұрын
Gloves won't hurt anything either.
@fabianaguilar34592 жыл бұрын
@@MrEvilTag Holding it properly would be by wearing gloves.
@MrEvilTag2 жыл бұрын
@@fabianaguilar3459 it has no exposed components that require it