2020 Can Am Spyder RT oil change.

Sorry the phone was upside down at one point.

[@brendarandall2364]

Good video, Thanks. Should mention before you pull the brake reservoir up and out... there's that little black tube that comes out first. I ended up breaking my tabs cause I didn't know that.

[@99shadows66]

That little black tube is nothing but a piece of 1/4 nylon air line tubing commonly used for airbag suspensions so I grabbed some 1/4 inch nylon air line tubing that I had lying around and cut a 4-inch length so I could easily remove and install it without cursing the engineers that used the short piece of tubing.

[@ES44AC-2]

Thanks for the video!

[@dennisdewald6729]

Don't let know one kid you the transmission oil plug is tighten to about 100lbs of torque from the factory. Take off the nut and pin that is right below it makes it easier

[@billwilliams9527]

Where did you buy the oil change kit?

[@JACKSGTS]

you can get one from any can am spyder dealer.

[@ralphplazachesmarhomes]

The RT 2020 first oil change is at what mileage?

[@Den-nu6pv]

3000

[@billwilliams9527]

exactly where do you place the jack to raise the vehicle?

[@JACKSGTS]

If you look under the trunk you will see where the frame and the trunk meet up . you will need a low profile jack to slide under it.

[@billwilliams9527]

OK, thanks Jack, did you lower for a total drain, or just leave it in the jacked up position. One more thing please, I read where one torx drain plug is difficult to access, so this person changed out both drain plugs to hex plugs. Did you find the torx plugs a problem? Thanks much for sharing.

[@nemesise1977]

Do you have a recommendation on a good jack to use?