2020 Harley Davidson Low Rider S dual gauge relocation (FXLRS)

We do a dual gauge relocation on the 2020 Harley Davidson Low Rider S! Parts used in the video are as follows:
Speed King Gauge Pod Bracket
www.speed-king...
31 State Dual Gauge block off covers
www.speed-king...
Guerrilla Cables speedo harness
guerrillacables...
Harley Davidson Speedo Tachometer cushions
part number 67104-95 (need 2)

[@ellissmithjr6599]

Just wondering🤔...Why not replace that dashboard as well? Get a vivid black flush mount cover that blends in with the gas tank...

[@darinmorgan5255]

What size Thrashin risers do you have? and what size Guerilla cables did you go with? Thanks much- clean set up.

[@riffraffchoppers]

Speedo left side for sure

[@ChopperFett]

I rode a lrs this weekend and I hated the stock gauge location. Had to keep looking down. Nice work man.

[@amptv2291]

yeah, it definitely crowds his eyeline a bit with the gauges up, but hes definitely pleased with the new set up. I think If I had a LRS I would absolutely do the conversion as one of my first moves

[@riffraffchoppers]

It’s called a dash hahaha

[@r3fund]

Nice work, boys! would have loved to see the bikini post-work; and I think you should get an outro going! HI TONY.

[@amptv2291]

Solid idea, its on my list of things to film

[@veerananmanoontham5456]

Nice bro , what handle bar size did you run. Thanks🙏

[@amptv2291]

These are just the stock bars with a riser

[@stephenuffindell]

Greet video how do you fix the blanking plates from the bottom or the top many thanks.

[@Sid_Mowe]

Thanks for the video. I just picked up a Low Rider S and I'll probably be relocating the gauges just like this

[@MrTransformers33]

How many gaskets did y’all buy four or two ? Or you reused the two that were on the gauges and only bought the rear gaskets ?

[@amptv2291]

We bought 2 of those old sportster gaskets for the rear, and then reused the stock ones for the front

[@MrTransformers33]

@@amptv2291 ohh alright that’s good How about for the length of the wire harness ? What length did yall go with because I am unsure what length to go with

[@amptv2291]

@@MrTransformers33 Well, I think your riser length will definitely be a factor in what you end up with. I don't actually remember what we ordered, as it was over the phone with speed kings. Your best bet to make sure its perfect, is to contact them directly and tell them the dimensions of your setup. Good luck man!

[@jamesbrusius9920]

What length cables did you guys use?

[@shane2one]

What screws did you use ?? I ordered the speed kings kit as well. But if didn’t come with hardware for mounting the plate on the back

[@TimJRoyal]

You use the same screws that you take out of the back of the speedo/tac from the dash.