This video is about how to change your 2021 4 stroke V6 Mercury outboard motor and gear oil. This is an easy DIY for anyone. This is a step by step video. I hope you enjoy the video. Thanks for watching the Thor Repairs channel!
Пікірлер: 9
@jameskodia5992Күн бұрын
Great vidéo
@famileeadventures4263Ай бұрын
Thanks for posting. Easy to follow and eased my anxiety doing both. I couldn’t find anything on our engines, everything was a ProXS or Verado Planning on doing one for LP fuel filter and impeller? 😉
@davorfsunjich52092 ай бұрын
thanks. great video
@davechristopher3370Ай бұрын
Thanks for posting. I just did my oil on my 200HP merc. For the lower unit, is it a different adaptor for the pump to replace the gear oil? I will be doing this part tomorrow.
@thorrepairs6557Ай бұрын
The pump I have worked fine. It didn’t thread in but it still did the job. Thanks for watching. Boat will be coming out of storage soon. 👍🏻
@danteach222219 күн бұрын
Nice video. I have the exact same year and OB as you though I keep my boat in the water 6 months of the year. I was told that when you use the flush port, the engine should be off and does not matter if the engine is down (out of the water) or up, when the boat is in the water. And was told by Mercury that the engine does not have to be warm to flush (when using the flush port). Though if using motor muffs, then the engine would need to be started. Just curious, did you receive different guidance? Thanks
@thorrepairs655719 күн бұрын
I’ve always used the flush port to warm the engine. I just followed what my manual said. I guess if Mercury told you other wise I would listen to them. 🤷🏼♂️
@danteach222218 күн бұрын
@@thorrepairs6557 OK thanks
@spinfish143414 күн бұрын
100 inch lbs converts to, 8.3 foot lbs… Torque Spec for the lower gear oil drain. Google is your friend.