(28 Nos) Nosler 175gr Accubond Long Range Expansion Test

[@Timberdam]

Good Review! I haven't used LRAB , But, I shot an Elk and a mule deer both over 400 yds with Nosler AB with great terminal performance with 300 WSM

[@burrito4x4]

Your target medium is not near as tough as an elk... all the bullets ive collected from elk were similar to your 100 yard example. This was at or beyond 500 yard shots.

[@sylviacandler5541]

I sort the 175g LRAB by ogive length, seat .003 within the lands, and they shoot very tiny groups!

[@arthurdirindinjr1792]

For a nonres coming from east of the Mississippi An average non guided elk hunt cost is in the $2k'3k+ range if you can maintain an extreamly tight budget A semi guided elk hunt is closer if not over $3k-$4k A fully guided bull elk hunt to a quality unit with a well regarded outfitter is north of $7k to $10k+ these days Spending $100-$130 on the one piece of equipment that is in a 4 way tie IMO for your most important of all your equipment of your boots your scope your rifle your optics and your bullet are are tied for the most important piece of equipment spending money on what will almost certainly be one of the cheapest must have items at +/- $130 is utterly foolish to concern yourself for a dollar amount that will equal to less than 0.05-0.001% of the total cost of your hunt and nothing is more important to your success or failure on a hunt and especially a bull elk hunt than your bullet. I did a crap ton of my own bullet testing of cup and core bullets from Hornady, Sierra, and Speer vs bonded bullets from Hornady and Nosler shot into 30" of newspaper taped securly but not tightly soaked in water for 3 days then allowed to drain for 1 day I placed a 1/2 sheet of PL in front of the box that held the newspaper and then a section of heavy thick shag rug in front of that Shot the .338/225 grain version of every bullet into the test box per my crono av/mv was 2870-2885 out of my 24" M700 at 75 yards the incident of cup and core separation was IMO unacceptable Although the bonded bullets lost 50-60% of their original weight they did mushroom excellent and remained intact All I hunt with now is NAB

[@goranmalnar5172]

Best chanall of bullet testing,great video guys👍

[@Eye_Guard]

I'd take the ABLR ove ELDX always.

[@Joel_Unbound]

I am a fan of both the Accubond and ABLR. The ABLR as stated by Nosler is for long-range hunting and starts to work best around the 500-yard plus range. Close range also is devastating but high loss of mass due to its thinner bonded outer metal. I've used ABLR at 85 yards to 500 on animals. It's a great bullet for its intent but many hunters likely don't need it. It's a Long Range bullet, as you state. I am a fan of the Accubond, ABLR, and Federal Terminal Ascent out of my 28 Nosler. I don't think people understand what a laser this cartridge is. I will say I ignore ft lbs as energy is not a killing unit of measure. Expansion based upon speed and construction are. The ABLR does what it's advertised to do, and does that extremely well. Whether its the choice for a hunter of course depends on their needs and hunting style. Great work - these videos you do are so useful IMO to so many.

[@frontlinerejects8029]

Thanks for your input!

[@ThemantleofElijah]

I recently bought some nosler accubonds 6.5, 140s and planning on reloading them into a 6.5-300 wby, I wonder how they will do with that kind of velocity gonna be like 3100 at muzzle. Should look close to the 28 nosler test perhaps

[@NHRifleman]

Great Job! My Browning Speed 26 barrel 7 RM performs similarly.

[@edstettin6799]

Excellent video. You did a good job here.

[@WayneGent-t2l]

Love your channel thanks for the hard work

[@RT-gv6us]

Great info! Wow. That was a windy day for shooting, but you guys still put it on target

[@jamesmooney5348]

Good job guys! Good video.

[@jamesmooney5348]

Really agree with your statements. Testing, only seems, to lead to the desire of more testing.

[@bradenherle8774]

Awesome review thanks

[@Workforaliving]

Great video... The 28 Nos speed is a great test for the ABLR. I really appreciate your videos on various bullets. especially when using the 300wm and 270wsm.

[@scottscheuerman8714]

I acquired some of these Nosler Accubond long range bullets in the 150 grain for my 280AI to make a hunting load for it I figured that this weight of bullets would give it plenty of velocity for it and balance out

[@The_Huntmaster]

Well done

[@FC2ESWS]

At 500 yards that thing is still smoking! I wonder what the max expansion distance is? Like 1500 yards?

[@FC2ESWS]

Have you guys ever shot the Cavity Back bullets? The supposedly have a really low expansion speed.

[@shawnkimble3949]

Glad you all did this review. I purchased a rifle and this exact ammo 2 seasons ago, and plan on using both this season.

[@WillyK51]

Almost no recoil, Care to mention the rifle Model and make? Trying to deside between 280 AI, 7mm RM or 28 Nosler

[@14goldmedals]

00:07 is your Huckleberry.

[@wolverinekut]

As always great job 👍

[@nebraskaman8247]

Would it be possible to show the bullet expansion with impact velocities between 2400-2000appx?

[@frontlinerejects8029]

Like we mentioned in the video we're going to run some 190's through a .308, that should get us into that velocity window.

[@romanko2736]

+

[@Patriotsoul]

Awesome data! I’d like to see your test on a 25-06 using the Speer 120gr grand slam.

[@frontlinerejects8029]

I would love to own a 25-06, I will acquire one at some point, thanks for watching!

[@Workforaliving]

same as .277 and .308 Hot cores and Grand slams

[@ronlowney4700]

🕵️‍♂️ I, first, want to answer your question on Why the Nosler ABLR and Not the ELD-X! Beyond what you elaborated upon, if you watch "Simple Minded Fella's" testing of these bullets into ballistics gel (a better way of understanding their performance), what you will see is that the Nosler ABLR bullet will begin it's large wound cavity at the 6" mark and extend 8" to 12" (depending upon caliber used) of it's dump in energy, before exiting the animal! Out of a 30-06, the 168 grain Nosler ABLR will penetrate 30" of ballistics gel (enough to go through an elk) while dumping the energy right in the center of the vitals (creating a 4" wide wound cavity about 10" long)! You would never see (understand) that with your type of test! This is exactly the kind of performance that you want on an elk, especially for a broadside shot! It should Also be Noted that it was at a velocity of 1,800 ft/s that he obtained these results in the 30-06 (though he tested it with the 308 Winchester and other calibers)! Even though Nosler rates this bullet down to 1,300 ft/s, he found that it would not perform well under 1,800 ft/s (often tumbling too)! You may want to test the 155 grain Terminal Ascent bullet out of your 270 wsm next, as it is the same length as that 165 grain Nosler ABLR bullet that you tested? I don't know if it will stabalize, however, because it doesn't have a plastic tip (so the bullets center of mass will be different)? 🤷‍♂️

[@frontlinerejects8029]

So you want me to run a .284 diameter bullet through a .277 diameter cartridge/barrel..? The only TA I could run through the 270 WSM is the 136gr

[@ronlowney4700]

🤣 No! On page #52 of the 2023 Federal Catalogue they Now have a 155 grain 0.277 Terminal Ascent bullet (not just the 136 grainer)! It has a similar Ballistics Coefficient (B C. = 0.585) as the 7mm 155 grain bullet (B.C. = 0.586) and in the same exact length as the 165 grain Nosler ABLR bullet that you just shot out of your 270 wsm (1.510" in length)! I don't know how easy it will be to find them, but the Federal Catalogue says that they are making them in 2023! 😜

[@frontlinerejects8029]

Well, it's not available for sale on their website yet, so unlikely I'll be able to get some anytime soon.

[@ronlowney4700]

🤔 Well, at least you know that they are making them now (Federal May Be Having Some Supply Chain Issues Too?)! 😜 It should be a fine bullet option for you! 🙂 Meanwhile, here is another "New" Bullet for you to try out of your 270 wsm: The 140 grain Badlands Bulldozer-2 bullet (B.C. of 0.650)! And, Who says that the 270 doesn't have any high B.C. Bullets? 😂 I would also tell you about the 136 grain 0.277 Lost River Ballistics J-36 bullet (B.C. of 0.650) that I've used, but the Factory is currently not selling to the General Public! I am not sure if it is because they are shut down because of supply chain issues or if they are just trying to fulfill all of their military contracts? Mabey they are loading that in 277 Sig Fury Ammunition for the military? Anyway, the Badlands Bulldozer-2 is for sale and "Simple Minded Fella" says that he is going to be hunting with it come fall! Happy Hunting! 🍻

[@ronlowney4700]

🤪 I never did ask you as to what powder load you used, when you shot the 165 grain Nosler ABLR bullets out of that 270 WSM?

[@jstraus34]

How is the recoil on the 28 Nosler? Doesn’t look that bad with the radial brake

[@shawnkimble3949]

I have an X-Bolt LR with a Recoil Hawg. I shoot this ammo and the kick is barely noticeable.

[@getmystride]

@@shawnkimble3949 Good stuff. I've got the recoil hawg for my 300 WSM and its pretty light as well.

[@frontlinerejects8029]

Running a Precision Armament M4-72, recoil is lighter than my 6.5 Creed.

[@jaypee389]

This is the best cartridge ever created.

[@82delta]

You never heard of the .416 Barrett huh?

[@jaypee389]

@@82delta ok sry. forgot about that one. that is amazing. pretty much the best. or .375 MERC; transitioning for life at 2500m

[@bradenherle8774]

7prc is a better choice

[@jaypee389]

@@bradenherle8774 Damn. That is also a good point.

[@14goldmedals]

Out of a 26" factory barrel on a Browning A-Bolt 7mm Rem Mag rifle I've loaded 150 grain Nosler Ballistic Tips with 63.0 grains IMR4350 chrony'd at 3250 fps. No pressure signs, Nosler manual max load. A lot of factory loaded 7mm Rem Mag are way under loaded. There are other guys loading way past the lawyer proof loads getting velocities hard to believe. It takes a little searching to find the forums. What about a properly loaded 7mm Rem Ultra Mag? Any of these chambers can be cut by hand by yourself to lengthen the throat to seat the bullets longer. It's only magazine length limitin you. The only real advantage to the PRC rounds is their brass is shorter so long seated bullets fit in the factory Mag lengths. It's simple to lengthen any magazine in bolt actions so the PRC advantage becomes moot. Hornady has been successful at targeting a new generation of shooters because the newbies don't yet know it's all been done before.

[@brandinh9736]

Love thay tot are using the 28 nosler. I have been trying to decide which bullet to use for a mainly hunting purpose out of my 28 Nosler. Open to any input from those on the channel!

[@brettstewart8765]

The bullitts talked about in this video would be a good place to start mate cheers Yogi 👍

[@burrito4x4]

They are too soft for close shots on elk so be careful where you hit under 500 yards...

[@brandinh9736]

@@burrito4x4 I don't plan on taking elk over 500 yards unless a lady resort, so that is good information. What brings you to this conclusion? Trying to learn as much as I can and curious what brought you to this conclusion

[@burrito4x4]

The five bullets I've pulled out of elk, all found on the far side skin. I feel they are perfect for deer sized game but just not tough enough for elk... atleast for less than desired points of impact... you hit one in the heart and it's game over but if you hit a bunch of muscle especially at close range and you might not find that elk... just want people to know real world results and not be shocked or upset to find out the hard way... not knocking them at all! They shoot amazing! Just an example and explanation of what they really do in the field.

[@brandinh9736]

@@burrito4x4 Appreciate the info. My ideal use case is mule deer and antelope, but did debate performance on elk. Very much appreciated your real world results. Might consider other options for elk moving forward. Thanks!