Nice tutorial very informative thanks for sharing your ideas
@rakhimehndiartcreation40432 жыл бұрын
Very useful sharing..
@zulquarnain86 Жыл бұрын
Hello Sir, best video explanation. Thanks. What will be the area for 45Deg Duct Elbow?
@ncengineeringtechnology3376 Жыл бұрын
Calculate for 90 degree then make it half
@AnGus_BulL3 ай бұрын
THANK YOU SIR FOR YOUR VIDEO I HAVE A QUESTION FOR RECTANGULAR DUCT REDUCER FORMULA AFTER CALCULATE THE w+h , THE w1x h1 NO NEED TO ADD INTO THE CALCULATION FORMULA? A=1.92M2 is complete size of this reducer? Thanks
@ncengineeringtechnology33763 ай бұрын
Yes You need to consider the largest dimensions, it is the estimate of sheet used for duct fabrication.
@rajamohamed91197 ай бұрын
On which standard this calculation is approved (eg. Smacna or Ashrae)???
@ncengineeringtechnology33767 ай бұрын
For fabrication you need to follow SMACNA or ASHRAE standards, It is for the cost, it is the estimate of sheets that used for the fabrication of duct, used for invoicing.
@kashifiqbal7657 Жыл бұрын
1000x200 It goes beyond 4:1 aspect ratio
@ncengineeringtechnology3376 Жыл бұрын
Thanks, This video is only to explain the method for duct area calculation.