Рет қаралды 406,265
( Advise volume caution )
3D printed Siren, Designed off the old dual, slotted WW2 design. Everything was made in solidworks, spliced by Simplify3D, Printed on a Wanhao Duplicator i3 printer. Parts done at 0.20mm layer height, 60mm/sec printing speed. Parts took between 2-4 hours to print ( each )
Sounded like a toy fire-truck with one blade. Sounds like a siren with two. Fairly happy with the design, the RPMs on here go much higher than needed, I only pushed it to 50% throttle, and it had no problems. 50% throttle ( to me ) sounded too high pitch / unrealistic. I will eventually arduino a 'Siren wind-up / wind-down' program, and try to mimic the real-deal as close as possible.