adventure channel @Mallrunner 2006 Toyota 4runner 4.7 v8
Пікірлер: 18
@israelrodriguez6986 Жыл бұрын
Great video! I just decided to spend more and replace the entire drive shaft than taking this route. But it’s good to know that this vid is here in case I decide to reference it in the future.
@ohsnapsitzjustin11 ай бұрын
Great content!! Love the vid will definitely be referring back to your channel for more fixes on my 3rd gen!
@wrenchingonthespectrum11 ай бұрын
Awesome! Thank you!
@henryduke7229 ай бұрын
Very good video thank you for your time in doing it
@wrenchingonthespectrum9 ай бұрын
Thank you
@sauln33274 ай бұрын
Thanks!! Great vid
@jameshenry25506 ай бұрын
Great video.
@wrenchingonthespectrum6 ай бұрын
Thanks!
@efil4kizum4 ай бұрын
most gen1 tacoma have that center support bearing two piece prop shaft
@griffenfarrell98823 ай бұрын
I took mine to a shop and they replaced the u-joint for $100. I think it’s the best option to do.
@wrenchingonthespectrum3 ай бұрын
Thanks for watching. Atleast this video showed you why it costed you $100.
@ToyoftheDay11 ай бұрын
good video, thanks. Have you ever changed the center support bearing?
@wrenchingonthespectrum11 ай бұрын
3rd generation 4runner don't have center support bearings that I know off. It's only found in the long bed pick up trucks. Either way, it's not a hard job.
@ToyoftheDay11 ай бұрын
I have a 2001 Tacoma, all of my u joints are tight, but the rubber bushing/bearing support is very worn, so I better install a new bearing/carrier support. thanks-@@wrenchingonthespectrum
@wrenchingonthespectrum11 ай бұрын
The only tricky part of doing the support bearing is the big nut ( about the size of an axle nut) that holds the bearing onto the drive shaft. That nut normally needs an impact gun to get off so that you arnt fighting the drive shaft from spinning. I believe it's bolted to the rear driveshaft. I could be mistaken
@ToyoftheDay11 ай бұрын
Good to know, thank you-@@wrenchingonthespectrum
@taigatapia790010 ай бұрын
question, is this the reason why mine vibrates going on highway and under 15 mph?
@wrenchingonthespectrum10 ай бұрын
I can't say for certain but a vibration at that low of a speed is most likely wheel bearing or tire being out of round. Ujoint vibration is normally felt on hard acceleration or around 50mph