4L60E 700R4 TH350 2WD Extension Housing Bushing and Seal R&R

Рет қаралды 1,227

Күн бұрын

Пікірлер: 11

@keltecfan 4 ай бұрын

Another great video, Nick. If you haven't considered or used one, give a Mason's chisel a try for knocking out old seals. I use a 2-3" mason/masonary seal that can be purchased at most home improvement stores. Been using this method for many years. I too remove the seals from the pump, and/or tail shaft housing seals while the components are still bolted to the transmission. Thanks for taking the time to share your knowledge.....

@nickstransmissions 4 ай бұрын

Thanks, Keltecfan! Will check out Mason's chisel, always looking for easier ways to remove those things so if it makes quicker work of them than my screwdriver, I'm in.

@Classics-Cars-and-Others07 8 күн бұрын

Thank you for you video. Very useful 👍

@nickstransmissions 8 күн бұрын

Thank you for watching, Classics-Cars-Others!

@patrickkoegel8320 4 ай бұрын

Hey Nick I have the 2000 4l80e when I bought this the seller said it had no reverse I got it tore down and come to find out that the front planet was pretty tore up the reverse band friction also fell off the band there are two types of front planets .795 tall pins and .710 tall pins should I get the .795 or .710 how do I know is there away of measuring them thanks

@gustavoescamilla6662 4 күн бұрын

I cant seem to find any TH350 bushing driver kit, can you recommend a replacement, or do the 4L60E fit the TH350 bushings? Its breaking my head this

@nickstransmissions 4 күн бұрын

Hi Gustavo, thanks for watching...You'll need to use bushing drivers from a variety of sets as I'm not aware of a TH350-specific driver kit. Someone on eBay makes a 3D-printed set for TH350s, perhaps that's an option if you're only going to use them once to a handful of times.

@tonypisellijr4941 3 ай бұрын

Thanks again for the content Nick. A few things: what are your thoughts on using something like Loctite 640 on the new bushing when you install it? I thought you used something similar on your video on repairing an input drum w/ a new shaft? Are those GM specified Kent Moore bushing drivers or just generic drivers that match the circumference of the bushing? Finally, how often is it that you see a bushing that won't fit over a yoke due to it being not "square" to the opening, i.e. one side is slightly higher then the other? Thanks again brother.

@nickstransmissions 3 ай бұрын

Thanks, Tony..You can use Loctite 640 or any of the red Loctite types. The bushing drivers are generic - bought them off eBay as a set about 10 years ago but you can get 4L60E/700R4-specific bushing driver sets (search Google, Amazon or eBay for sellers of these sets - you will find them if you need a set for yourself). It's maybe one out of every 50 or so bushing kits where I get an ext housing bushing that is out of spec so actually glad it happened on camera as it will gives folks awareness around the possibility.