$50 DIY Cold Air Intake! Mercedes Benz CLA

[@DanielMartinez-vw4ik]

I hate that he skips the video during the hardest part of the install; putting in the new tubing. I was able to get it in by using a little bit of grease and shaving down the side that lead to the turbo a bit. Lmk if this helps 👍🏻

[@coreycarter8469]

Good job. You got some sound but you are just sucking hot air now killing power

[@PKDesigns2011]

I tried those filters before and in all honestly if you are on partial throttle it will be ok but wot these restrict to much and on higher output vehicles that need more air I would recommend going with something that flows bit more air lie a AFE, K&N or AEM otherwise you will get the reverse effect ...

[@BSBoading]

The filter he used that brand is made by k&n

[@SLOWCLA]

Did you feel loss of power or acceleration

[@MFvids]

It was nearly impossible to put the pipe to the car ! Be careful with disconnecting anything !

[@AimanAmirul11]

Do you have any problem after installing this? any different to the car?

[@hwbt3126]

Bo problems. More throttle response better sound

[@AimanAmirul11]

@@hwbt3126 alright thanks..gonna make same setup as yours soon

[@SNA6188]

Are there problems after installation?

[@hwbt3126]

No

[@SNA6188]

@@hwbt3126 Thx💛

[@702xRyder]

Sounds amazing bro wish my q50s sounded like this What size is the Pope you used 3 inches ? I don't know why people hating I rather do this than spend 500

[@44.អ៊ុកដារិន]

Check light engine or not ?

[@hwbt3126]

No no check engine light

[@joshualagunas847]

where did u purchase bov?

[@hwbt3126]

I got all of it from autozone

[@joshualagunas847]

@@hwbt3126 but what size is it

[@joshualagunas847]

@@hwbt3126 autozone has diff sizes

[@joshualagunas847]

inch size

[@Dee93705]

That not good for his engine suck all that hot air the cover won't fit because he had to remove it for that aftermarket filter to fit