722 9 speed sensor changing video

[@roasameer]

Could you explain what happened in the car so you had to change this sensor?

[@marekdreed88]

Speed sensor i think

[@franciscoisaias1722]

Shifts into gear really hard from park, doesn't change speeds

[@a.elmehni6954]

Good video

[@anasel9934]

Hello, after changing speed sensors, did we need to set it up or to sychronise it by the star diag

[@johnwet5798]

Nope

[@symbianfreak01]

Nope just clear the codes

[@aidensamuel1147]

Sorry to be so off topic but does anybody know of a tool to log back into an Instagram account..? I was stupid lost my account password. I would love any tricks you can offer me

[@kevinwalker5155]

@Aiden Samuel instablaster =)

[@aidensamuel1147]

@Kevin Walker i really appreciate your reply. I got to the site through google and I'm in the hacking process now. Takes a while so I will reply here later with my results.

[@felipes7446]

hello I have the error Y3 / 8N1 (turbine speed sensor), I want to know if I can change the part I have to re-synchronize the box, and I want to know where I can buy. regards

[@rusty358]

What type solder and flux do you use?

[@glasser2819]

looks like just regular solder type, nothing special there 🙂 Besides you really need a "temperature controlled solder-iron" (not the $5 one time use junk iron) - Nothing super fancy, as long as its the right soldering temperature it won't damage the fragile flex cable 👍🏻

[@rusty358]

@@glasser2819 If you make a hole on the bottom to punch out the sensor, do you need to seal it up?

[@glasser2819]

@@rusty358 one would think so... better not dismantle everything again !!

[@koisk4983]

How did it not break???

[@grcicstevan]

where is possible to purcase these replacement sebsors?

[@glasser2819]

@@Transmission4less thank you!

[@vuonghau6779]

This will break the board and you need to replace the whole thing. Warning!!!!

[@rusty358]

If you make a hole on the bottom to punch out the sensor, do you need to seal it up?

[@Gatsu3D2A]

There's a tool to remove them that works better

[@franciscoisaias1722]

Parts changer I see lol

[@rhryguy]

😢

[@juanmanuelbenitezaguilar7025]

hello friends what happens with the N3 sensor I also want to put new

[@sylvia-transnationautotran4116]

Hello, I don't know neither. We don't have that sensor.

[@marionmitchell261]

Is this a comedy? Did the car drive afterward?

[@yavorpetrov2081]

Realy unprofesional! You must use a specialized tool for disassembly...... different from hammer :-) You reach for the hammer too easily. Given the cost of a new one and the subsequent adaptation.

[@brizniz4shiz44]

Chinese sensor no good