770M/MX and 1100M/MX ATC Maintenance and Troubleshooting

[@canardsalle7731]

Thanks for this video. I had 3-4 low pressure alarms every tool change @ 90-100 psi. Not mentioned in the video but you need to unscrew the small screw between the 2 wire connection to increase the pressure in the low pressure sensor. For me it was 2 turns counterclockwise until the warnings were gone. Machine works flawlessly now.

[@ClockwerkIndustries]

Im having a homing issue with the ATC any content on that? Im about to call service to see what can be done, the whole ATC shakes like its about to explode and then in stalls out and throws up ATC homing error, this is when it calls the ATC to spin to change tools, not on the pneumatic end of things.

[@TormachTechnicalSupport]

A video on homing errors is on my todo list, but I haven't had time to film it yet. The ATC shaking doesn't fit the normal issues, though, I would recommend opening a support ticket and sending us a video of the behavior. -Norman

[@domlaiso7034]

Im losing it. This atc is such a waste of money, and has had nothing but problems since installing. The cycle timing on mine is now messed up so it just drops the tool right when i try to load it.

[@domlaiso7034]

Thanks for going over that btw... "this could be an issue with the solenoid where it's sticking" *completely moves on with no explanation* very helpful👏