Does NOT work with factory length springs. Repeat. Does NOT work with factory length springs. Only thing i found for factory springs is a spring compressor OTC 7045B. Its hella expensive but it made this job hella easy
@MUSTANGVERDE2 жыл бұрын
Great vid. Why not clean the control arm and suspension before instaling the spring ?
@WilliamGreenlee2 жыл бұрын
For a very important reason. Laziness.
@RichardBrown-i9p Жыл бұрын
Says tool is only for lowering springs Not stock springs
@JeasonRomo022325 күн бұрын
Cómo se llama esa herramienta?
@anthonygrebner Жыл бұрын
Now, use that tool with stock length springs. Nope.
@dannyvenegas3086 Жыл бұрын
Got one in with spring compressors but sketchy af any other methods?
@jamesa6272 Жыл бұрын
Exactly. This tool says will not work with stock springs. I also did not disconnect the tie rod from the hub. No need to. Just unbolt pop the ball joint and move the hub assembly to the side. You will have to loosen the a arm bolts to get the arm to swing completely down to get the springs in.
@jamesa6272 Жыл бұрын
Just to add to this. I bought this mm tool and it was a life saver. I put my Stock springs back in with no problems whatsoever using these. Then I replaced the stock springs and used this tool again with eibach prokit springs and it was a even easier install. Install was a complete breeze with this tool!
@bryanr57562 жыл бұрын
Ordered.. just sucks shipping was just as much as the part!
@bryanr57562 жыл бұрын
CANCELLED my order.. 6 week wait for such a small tool
@gz_illuzion27292 жыл бұрын
What’s the parts called that you used…..?
@daryllect6659 Жыл бұрын
That's a Turbo Encabulator.
@daryllect6659 Жыл бұрын
3:22 ~ You obviously should have started with the car jacked up higher.
@RA-lk1vz3 ай бұрын
Dang that suspension was a death trap!!!
@GarnetMiller-sy5jl4 ай бұрын
Isolators will stop that from spinning
@jeffreywhite76579 ай бұрын
ILL NEVER do it this way again. Ill replace with coil overs.
@tatumwilliams21928 ай бұрын
I just put two front springs on a 98 gt. Holy. Fucking. Shit.
@suburbangardenpermaculture31177 ай бұрын
I'm here trying to figure out how 1A auto videos just... jack up the A arm and viola!! Yeah, it aint no viola.
@jeffreywhite76577 ай бұрын
@@suburbangardenpermaculture3117 I was so freaking pissed off when I was replacing these it made me sell it 🤣
@suburbangardenpermaculture31177 ай бұрын
@@jeffreywhite7657 broski, I am waiting I. The car for my wife RIGHT NOW about to go rent a spring compressor from O'Reillys🤣👌
@jeffreywhite76577 ай бұрын
@@suburbangardenpermaculture3117 Don't do it! They suck!!
@jakub5842 жыл бұрын
Do you just leave the tool in the control arm
@WilliamGreenlee2 жыл бұрын
No you remove it. It can be removed with the spring installed.