80cc Motorised bike bucking bar failure/upgrade

[@shannon6815]

Nice trick sir, good job. 👍

[@Motorizedstuff]

Thanks sorry for late reply youtube for you not sending notifications lol but yeah it worked really well to be honest never had a problem since

[@Bobs-yer-uncle]

I just found this problem on my engine did your fix work out long term I'm probably gonna hafta replace it eventually but I want to run it as long as possible and any ideas on how this happened 😅

[@Motorizedstuff]

I really don't to be honest suppose there nothing to stop it spinning around in side sk the pice I put in mine was made from a snapped socket piece ground down I left the edge on it so it would fit in the engine side casting to keep it from spinning and it did work but for long time can't give you that answer as the police tool my bike it's on my channel check it out lmao

[@Littleevil9975]

Dam that sucks bro

[@Motorizedstuff]

Yeah hopefully I have solved the problem the metal that was used to start with was softer and a little too short so hopefully with this in it should be OK 👌👍

[@Littleevil9975]

I agree there bro hopefully it’s better now

[@Motorizedstuff]

@@Littleevil9975 I also put the end lk I did cos of the hole in the engine casing it will keep.it more still and stop it from moving around while the engine is running

[@Littleevil9975]

That’s good bro

[@Motorizedstuff]

@@Littleevil9975 Just letting you know bro I went on a big ride out today done a good 40 miles and my clutch is exactly the same as it was so I think my improvement has worked 💪